The Power Stop Z26 Street Warrior front kit (K4539-26) pairs drilled and slotted rotors with Z26 carbon-fiber ceramic pads for street-driven performance cars. The manufacturer says the Z26 compound uses carbon fiber to improve heat handling over a typical ceramic pad, which helps hold stopping power at high speed. Stainless-steel shims, stainless hardware, and hi-temp brake lubricant are included, so you won't need to source hardware separately.
The manufacturer positions this kit for high-horsepower muscle and modified cars, where stock brakes tend to fade under repeated hard stops. Its low-dust, noise-free pad formulation also means less wheel cleaning than a standard semi-metallic setup. Because the rotors and pads are sold as a matched set, you get a complete front upgrade in one purchase. Searchers looking for 1971-1973 Buick Centurion front drilled slotted rotors, carbon fiber ceramic pads, or a Z26 street performance brake upgrade should confirm fitment for their exact vehicle before ordering, since application details can vary between sources.
The manufacturer describes the standard Z26 Street Warrior upgrade kit as including pads, rotors, and stainless-steel hardware. Its powder-coated caliper version is a separate kit, so confirm the part number before ordering.
Yes. The manufacturer states that break-in is critical to brake performance because it establishes an even layer of friction material on the rotors. Its procedure involves a series of moderate to aggressive stops without letting the brakes cool, followed by a gentle drive.
This is a front brake pad and rotor job that calls for a floor jack, jack stands, a torque wrench, and a standard socket set, and it is manageable for a home mechanic with basic experience. The kit includes the pads, rotors, stainless hardware, and lubricant, so you only need the tools. Support the vehicle securely on jack stands, and clean the caliper bracket and hub surfaces before fitting the new rotors. Check rotor runout before final assembly, because excessive runout can cause pedal pulsation. If you open a bleeder or loosen a brake line, bleed the system before driving. After installation, follow the manufacturer's break-in sequence: five moderate-to-aggressive stops from 40 mph to 10 mph, then five stops from 35 mph to 5 mph, then about five minutes of moderate driving without heavy braking.