The Power Stop Z36 Truck & Tow Brake Upgrade Kit (K9206-36) is a front-axle pad and rotor package for the INFINITI QX60. It combines the Z36 carbon-fiber ceramic pad, drilled and slotted rotors, and stainless-steel hardware. The manufacturer built the Z36 compound to handle more heat and load than a typical ceramic pad, which suits QX60 owners who tow a trailer, haul gear, or drive mountain grades. The drilled and slotted rotors are designed to shed heat during repeated hard stops.
Compared with a standard ceramic pad or an OEM replacement, this kit targets severe-duty stopping while keeping the low-dust, quiet behavior expected from everyday ceramic pads. The rotors and pads are sold as a matched set, which matters because owners on user forums report that pad material must suit the rotor choice. The kit includes premium stainless-steel hardware, a pin bushing kit where applicable, and hi-temp brake lubricant. Searches for "QX60 front brake upgrade for towing," "Z36 carbon-fiber ceramic pads," and "drilled slotted rotor QX60 front kit" lead to this exact configuration.
No. The manufacturer offers a separate Z36 kit that includes powder-coated calipers. This K9206-36 kit is the pad and rotor package.
Yes. The manufacturer calls break-in critical to performance. It recommends several moderate stops from about 35 mph to 5 mph without letting the brakes cool, and advises against cooling the brakes with water.
The kit is designed as a bolt-on replacement for the front pads and rotors, and the manufacturer includes the hardware and lubricant needed for the swap. Plan on a floor jack, jack stands, wheel chocks, a socket set, a flat-head screwdriver, C-clamps, and a Torx driver for the rotor screws. When replacing pads, owners on user forums recommend cleaning and lubricating the caliper slide pins, since a seized caliper is a common problem on the QX60. Torque specifications vary by vehicle, so confirm them in the service manual before reassembly. Finish with the break-in procedure to establish an even pad transfer layer on the rotors.