Power Stop's K8774 is the rear-axle member of its Z23 Evolution Sport line, built for the 2021-2025 Acura TLX. The core is a carbon-fiber ceramic pad paired with drilled and slotted rotors, and the manufacturer groups pads, rotors, and stainless fasteners into one bolt-on package. Buyers searching for a rear TLX brake kit with carbon-ceramic pads and drilled rotors are looking for this exact configuration.
The manufacturer says its carbon-fiber ceramic compound significantly enhances braking performance versus traditional ceramic brake pads, and the pads are marketed for lower dust output. The rotors use zinc plating for corrosion resistance. Owners on user forums are split on drilled rotors: some report stopping power is essentially the same as OEM, while others warn about cracking. Weigh that tradeoff before paying for the upgrade over stock.
Plan on a standard rear pad-and-rotor job. Power Stop's general install sheets advise not letting the caliper dangle from the brake hose, greasing the edge of the pad backing plate where it contacts the caliper bracket, and returning the piston when fitting thicker pads. Finish by bleeding the system and replacing brake fluid to the MAX line. Then follow the manufacturer's break-in procedure, which the company calls critical to brake performance.
The manufacturer states the Z23 kit includes pads, rotors, and premium stainless-steel hardware, and its kit listing also includes hi-temp brake lubricant. Confirm the exact contents for K8774 against the manufacturer's packing list before ordering.
Yes. The manufacturer offers a separate Z23 Evolution Sport kit that adds powder-coated calipers, which the company describes as high-heat powder coating. The K8774 listing covers pads and rotors only.
User forums are divided. Some owners report braking similar to OEM, and others caution that drilled and slotted rotors offer limited street benefit and can crack. Buyers who mainly want looks or cooling should expect modest gains; those seeking a major stopping-power jump should weigh that against the forum warnings.
This is a bolt-on rear job for a home mechanic comfortable with a floor jack, jack stands, and a torque wrench. Power Stop's general install guides call for a C-clamp, DOT 3 or 4 brake fluid, and brake grease. Gotchas include the caliper piston needing to be pushed back for thicker new pads, and the rubber boot sometimes extending the caliper bolt and causing interference. Confirm the TLX-specific torque values and steps against the manufacturer's sheet before starting.