The Power Stop K8741-36 is a front brake upgrade from PowerStop's Z36 Truck & Tow line, sized for 2021-2022 Chevrolet Colorado trucks that tow, haul, or run hilly terrain. The kit pairs carbon-fiber ceramic pads with drilled and slotted rotors, which the manufacturer says reduce rotor temperatures during extreme braking and help clear dust and gas. Factory pads and blank rotors are built for everyday loads, so this kit is justified mainly when towing or steep grades push stock brakes toward fade. Owners on user forums note that aftermarket pads often trade some dust and pad life for extra bite, so weigh that tradeoff against your use. Searching for 2021 2022 Colorado front brake towing upgrade, Z36 carbon ceramic pads, or K8741-36 install should lead you to this exact kit.
Confirm fitment against your VIN, trim, and wheel size before ordering, since heavier tires or lift setups change braking loads. The manufacturer frames the kit as a bolt-on upgrade that includes stainless steel hardware and wear sensors, so no modifications should be needed on a stock front end. Plan on bedding in the new pads and rotors with the manufacturer's break-in sequence before any heavy towing trip.
The manufacturer offers its Z36 Truck & Tow kit with powder-coated calipers as a separate product, so this pad-and-rotor kit is intended to work with your existing calipers. Check the manufacturer's listing for the exact contents before ordering.
The manufacturer describes break-in as critical to performance. It calls for a series of moderate stops from 35 mph to 5 mph without letting the brakes cool between them, followed by a cooling stage. The manufacturer also advises against cooling the brakes with water.
The manufacturer presents this as a bolt-on swap, and its install guidance indicates a knowledgeable DIYer can complete it at home. Plan on a jack, jack stands, a socket set, a torque wrench, and a C-clamp or caliper piston tool, because the new pads are thicker and the piston must be pushed back before the pads fit. Set the parking brake and support the caliper with wire so the brake hose is not stressed. Apply brake grease only to the backing plate contact points and keep it off the rotor. Confirm torque values against the manufacturer's install sheet, then complete the break-in before towing.