The Z26-2516 is the front pad set in PowerStop's Z26 Street Performance line, a carbon-fiber-reinforced ceramic compound the manufacturer aims at muscle cars and high performance vehicles. The manufacturer also specifies a powder coated backing plate that resists rust and corrosion, and says the pads resist fade up to 1500 degrees. Owners on user forums say the factory Dark Horse pads are very dusty, so buyers switching to a low-dust carbon-ceramic Mustang brake pad are usually after a cleaner-wheeled, fade-resistant setup for spirited street driving.
Fitment is the first thing to verify. Owners on user forums report that they changed the front and rear pads on a 2024 Dark Horse with PowerStop Z23 or Z26 pads and have never been disappointed. Brake package details for the GT and EcoBoost trims vary across sources, so confirm your front caliper setup before ordering. The manufacturer's warranty runs 90 days / 3,000 miles and excludes failure of components due to disc thickness variation.
Plan on bedding these pads before any hard use. A member of a user forum notes they were told to go through the bedding process unless you buy pre-bedded pads, and another suggests 4 or 5 hard stops from 100kmh. Owners also recommend a thin film of brake grease on the back of the pads, which helps quiet the brakes, in addition to keeping the hub surfaces clean.
Owners on user forums say bedding is recommended unless you buy pre-bedded pads. One forum member suggests four or five hard stops from roughly 100 km/h as a starting point.
The manufacturer provides a 90-day/3,000-mile warranty. It does not cover failure from disc thickness variation or normal wear.
Owners on user forums apply a thin film of brake grease to the back of the pads, which they say helps prevent vibration noise without harming the piston boots. Keep grease off the friction surface and wheel lugs.
A first-time DIYer on a user forum described pad swaps as fairly straightforward after watching online videos. Front-pad posts describe removing two retaining pins, taking out two 60 mm caliper bolts, and using a caliper spreader to seat the new pads. Before reinstalling, owners clean the hub surfaces and wire-brush any rust. Some recommend cracking the front bleeder and pushing the pistons back slowly so debris doesn't enter the lines. Ford service manual pages covering front pad replacement have been shared among Dark Horse owners on user forums, so check those before you start.