The Power Stop K8764-36 is a complete rear brake upgrade from the Z36 Truck & Tow line, built for a 2021 Ford F-150 with 336mm rear rotors. The kit pairs carbon-fiber ceramic Z36 pads with drilled and slotted rotors, and it ships with stainless steel installation hardware and high-temperature brake lubricant. The pad compound is a reinforced ceramic formula, designed to handle heavier loads than standard ceramic friction material.
Why pay more than for a basic replacement set? The case is strongest for owners who tow a camper, haul a work trailer, or drive a lifted truck through mountain grades, where repeated stops generate heat. Drilled and slotted rotors help carry heat and gas away from the friction surface, and the zinc-plated finish is intended to resist rust. Owners on user forums who have run PowerStop pads on Ford trucks report less brake dust than stock, though results vary by driving style. Buyers comparing the Z36 with the lighter Z23 for an F-150 often ask how often they tow; owners on user forums suggest the Z36 for regular heavy towing, while the Z23 suits mostly daily driving. Searches for 2021 F-150 towing brake kit, 336mm rear rotor upgrade, and carbon ceramic Z36 pads point to this exact application.
Owners on user forums note that standard 2021 F-150s use 336mm rear rotors, while max-tow trucks can be equipped differently. Measure your rear rotor diameter or check your build sheet before ordering to confirm the kit matches your truck.
Owners on user forums generally recommend the Z36 for drivers who tow regularly, often cited as more than six times a year, and the Z23 for mostly daily driving with occasional towing.
Yes. The rear electronic parking brake motors need to be retracted into service mode before the rear calipers can be pushed back to make room for the thicker pads and rotors.
This is an intermediate rear brake job that most home mechanics can complete in roughly one and a half to two and a half hours with a floor jack, jack stands, a torque wrench, and a C-clamp or caliper compressor. Before pulling the calipers, put the electronic parking brake into service mode, following the sequence in the vehicle's procedure, because the rear caliper cannot be compressed otherwise. Expect brake fluid to rise in the reservoir as you push the pistons back, so remove a little with a clean syringe first. Owners on user forums recommend replacing the caliper bracket bolts rather than reusing them, and they advise applying the included lubricant to the caliper contact points and the pad backing rather than skipping it. Use a torque wrench on the caliper bracket and slider bolts, and do not use threadlocker on the slider pins. Finish by pumping the brake pedal before driving and bedding in the new pads gradually.