The PowerStop Z23 Evolution Sport front kit for the 2014 Mercedes-Benz C300 pairs carbon-fiber ceramic pads with drilled and slotted rotors and stainless-steel hardware, sold as one bolt-on set. The manufacturer says its Carbon-Fiber Ceramic Z23 compound significantly enhances braking performance versus traditional ceramic brake pads. The pads are also built for low dust, so wheels stay cleaner than with typical street pads. The manufacturer states these pads combine with Drilled & Slotted rotors to ensure a cool braking system, which is the main reason to choose this kit for a daily-driven C300 that sees occasional hard stops.
Compared with a basic replacement set, the value is in the matched pad-and-rotor system and the complete hardware package. The kit comes with pads, rotors, and premium stainless-steel hardware for a bolt-on upgrade. Verify fitment against your VIN before ordering, since the manufacturer's application chart for K7496 could not be located during research. Also confirm your front rotor type against the application listing. Caliper-equipped versions are a separate SKU, so a buyer who wants new calipers must choose that version.
No. The standard Z23 Evolution Sport kit covers pads, rotors, and hardware. The manufacturer sells a separate version with powder coated calipers that includes pads, rotors, calipers and premium stainless-steel hardware.
According to the manufacturer, the goal of a proper break-in is to establish an even layer of friction material deposited on the rotors from the brake pads. An imprint on the rotor may contribute to the creation of brake judder. The manufacturer's break-in for this kit starts with 5 moderate to aggressive stops from 40 mph down to 10 mph in rapid succession without letting the brakes cool. Details vary by rotor type, and the manufacturer's install guide lists a different routine for its coated-rotor kits, so confirm the correct procedure with the manufacturer.
Per the manufacturer's installation guide, have brake fluid that matches the owner's manual, brake component lube, and safety glasses and gloves ready before starting. The brake fluid reservoir should be about half full. Never let the caliper hang from the brake hose, since this can cause damage to the brake hose. Keep lube off the pad friction surface, and torque the caliper bolts to the manufacturer's specifications. Use the stainless hardware included in the kit, because worn or damaged hardware can lead to noise or poor brake pad performance. Finish with the bedding procedure above before any hard stops.