Power Stop's Z23 Evolution Sport front kit for the 2013 Infiniti JX35 pairs carbon-fiber ceramic brake pads with drilled and slotted rotors, so the friction material and discs arrive matched in one box. The manufacturer built the Z23 compound to deliver more braking power than traditional ceramic pads while producing less brake dust. The drilled holes are meant to pull heat away during hard stops, and the slots clear gas and debris from the pad face. Stainless-steel hardware and a pin bushing kit are included for a clean bolt-on swap.
Compared with stock replacement parts or budget pads, this kit suits a JX35 owner who wants firmer stopping and cleaner wheels without buying a full big-brake setup. Owners on user forums commonly report much less wheel dust and quiet operation. Other forum posts describe rotor corrosion in salt-heavy climates and rotor warping, so reports vary and regular rotor inspection is worth the effort. This is a pads-and-rotors kit; the manufacturer offers a separate version with calipers if your current calipers need replacing. Long-tail searches for a 2013 JX35 front Z23 carbon-fiber ceramic pad and drilled slotted rotor kit should lead here.
No. This kit covers pads, rotors, hardware and lubricant. The manufacturer offers a separate Z23 Evolution Sport kit that adds powder-coated calipers if you want to replace them as well.
Yes. The manufacturer states that break-in is critical to brake performance, because it lays an even layer of friction material on the rotors. Follow the break-in steps in the installation section below to avoid uneven pad deposits.
Yes. The manufacturer lists hi-temp brake lubricant among the included items, which is used on the caliper guide pins and pad contact points during installation.
This is a manageable front brake job for a home mechanic with basic tools. Gather a floor jack, jack stands, a C-clamp, DOT 3 or 4 brake fluid, and brake pad grease. Per the manufacturer's install guide, chock the rear wheels, set the parking brake, and loosen the lug nuts before lifting the vehicle onto jack stands placed at the frame support points. Remove the caliper bracket bolts, and do not let the caliper hang from its hose. Clean rust from the caliper rails with a wire brush, and use a C-clamp to retract the piston with the old pad over it to protect the surface. Before reassembly, the manufacturer recommends checking rotor runout, and the guide calls for bleeding the brakes afterward to remove air. Some owners strongly recommend using anti-squeal grease only on the backing plates, never on the friction surface. Afterward, complete the manufacturer's break-in: five moderate to aggressive stops from 40 mph to 10 mph without letting the brakes cool or coming to a full stop, then five stops from 35 mph to 5 mph, and then allow the system to cool.