The Power Stop K1559 is the front-axle Z23 Evolution Sport brake kit for the Cadillac XLR, a convertible sold across the 2004 to 2009 model years. The manufacturer builds the Z23 line around a Carbon-Fiber brake pad formulation and pairs it with stainless-steel hardware and a pin bushing set, so you don't have to source matching slide hardware separately. Stopping-distance figures against stock pads aren't published for this kit, so treat any gain over OE as a qualitative improvement. What you're paying for is a matched, purpose-built pad package that stays consistent under repeated hard stops, plus hardware that holds up to the corrosion and wear that cheap replacement sets often miss.
Enthusiasts typically search for terms like 2004 Cadillac XLR front brake pads, Z23 carbon-fiber ceramic XLR upgrade, and XLR track day brake pads. Fitment for the 2004 to 2009 XLR is not consistent across year and trim in the information we could verify, so confirm your application by VIN with the manufacturer before ordering. Bedding in is a critical step: the manufacturer stresses that an even layer of friction material must be deposited on the rotors. Holding the pedal down on hot rotors can imprint the pad surface and contribute to brake judder, so follow a deliberate break-in procedure once the job is done.
Yes. The manufacturer describes the Z23 Evolution Sport pads as designed to perform as a kit, with premium stainless-steel hardware and a pin bushing kit for installation.
Yes. The manufacturer states that break-in is critical to brake performance, and that an even friction layer on the rotors is the goal of the procedure.
Not confirmed for every trim. Fitment details that could be verified vary by model year and trim, so check your specific XLR against the manufacturer's application data before ordering.
This is a front-axle pad and rotor replacement, which is a manageable weekend job for a home mechanic with a jack, jack stands, a torque wrench, and standard hand tools. Chock the rear wheels, loosen the lug nuts before lifting, and support the car on jack stands placed at the frame points, never on a jack alone. Keep the stainless hardware and pin bushings together and clean the caliper bracket before reassembly. After the install, complete the manufacturer's break-in procedure to avoid pad imprinting and judder.