The Power Stop K8773-36 is the rear-axle half of PowerStop's Z36 Truck & Tow upgrade for the 2020-2022 Toyota Highlander. It combines Z36 carbon-fiber ceramic brake pads with drilled and slotted rear rotors, so you get a matched rear pad and rotor package instead of sourcing parts separately. The manufacturer describes the Z36 friction material as a low-dust ceramic blended with carbon fiber, which it says makes the compound strong enough for heavier loads while still quiet in everyday driving. It is positioned as an upgrade over stock rear brakes for owners who tow, haul, or drive mountain grades in a 2020-2022 Highlander.
The reason to choose this kit over a basic replacement pad is sustained stopping power under load. The manufacturer engineered the system for towing a boat or trailer, hauling, mountainous driving, and lifted trucks, and the drilled and slotted rotors are meant to move heat away faster during repeated hard stops. The box includes premium stainless-steel hardware, a pin bushing kit where applicable, and hi-temp brake lubricant, so the job is ready to bolt on. Confirm your exact trim and submodel against the manufacturer's fitment lookup before ordering, since fitment listings vary. Searches for 2020-2022 Highlander rear brake upgrade, towing brake kit, carbon-fiber ceramic rear pads, and drilled and slotted rear rotors are the best match for this part.
The manufacturer offers a separate Z36 version that includes powder coated calipers, so this rear pad and rotor kit is intended for use with your existing calipers.
Owners on user forums report that on electronic parking brake models, the rear caliper piston has to be retracted with a Toyota scan tool such as Techstream before the new pads can go in. Forum posts also note that the standard parking brake-switch procedure shown in some online videos did not work for every owner.
This is a bolt-on rear pad and rotor job that most home mechanics can handle with basic hand tools, a caliper piston compression tool or large C-clamp, and a flathead screwdriver. The main gotcha is the electronic parking brake on many 2020-2022 Highlanders, which typically requires a scan tool to retract the piston before the caliper can be compressed. Do not press the brake pedal while a caliper is off, because the manufacturer warns that the pad can then press an imprint into the hot rotor, which may contribute to brake judder. Use the hi-temp brake lubricant included in the kit, and follow the manufacturer's install instructions for torque and bedding.