The PowerStop K8491 is a rear brake upgrade kit from the Z23 Evolution Sport line. It pairs carbon-fiber ceramic pads with drilled and slotted rotors, and the manufacturer describes the Z23 pads as a low-dust formula that adds stopping power over stock pads. For a daily-driven Stinger that sees spirited back-road or occasional track use, a matched pad and rotor set removes the guesswork of choosing compatible parts one at a time. Published application data varies across catalogs, with model years listed from 2018 through 2023 and some Genesis G70 entries, so confirm your exact year, trim, and rear caliper setup with the manufacturer before ordering. Owners on user forums describe rear pad swaps as straightforward, though rotors can be stubborn to free from the hub.
Plan the job around the manufacturer's install guidance: check that the brake fluid reservoir sits about half full, support the caliper with a hanger instead of letting it hang from the brake hose, and watch the reservoir while compressing the pistons so it does not overflow. Clean the rotor hub, torque the bracket and caliper bolts to the manufacturer's specifications, and keep brake lube off the friction side of the pads. Owners on user forums also mention corroded rear pad plates and pad clips that need a pin punch to remove. Keywords: Kia Stinger rear brake pads and rotors, Z23 carbon-fiber ceramic rear brake kit, Stinger drilled and slotted rotors, low-dust rear brake upgrade, Stinger rear pad bedding procedure.
The manufacturer recommends five moderate stops from 35 mph to 5 mph in rapid succession without letting the brakes cool, followed by a cooling drive of roughly five minutes at moderate speed without coming to a complete stop. The manufacturer notes that proper bedding helps prevent rotor warping.
No. The manufacturer's install guidance says never to let the caliper hang from the brake hose, because that can damage the hose. Support it with a caliper hanger or a wire hanger while the pads and rotor are changed.
This is a manageable rear brake job for a home mechanic comfortable with jack stands and a torque wrench. The manufacturer's install steps call for brake pads, brake fluid specified in the owner's manual, and brake component lube, so have those ready before you lift the car. Owners on user forums report that the rear pads go in without much trouble, but rotors can stick to the hub and rear pad plates may corrode, so a wire brush, brake cleaner, and a pin punch help. Work one corner at a time so the opposite side stays intact as a reference, and confirm torque specifications in the owner's manual before final assembly.