Power Stop's Z23 Evolution Sport front kit for the Kia Stinger pairs drilled and slotted rotors with carbon-fiber ceramic pads, so the front axle is upgraded as one matched set. The manufacturer describes the Z23 pad compound as carbon-fiber reinforced, aimed at fade-resistant stopping and cleaner wheels, and says the hardware is stainless steel with a pin bushing kit for installation (Carbon-fiber reinforced ceramic formula for superior, fade-free braking power and cleaner wheels. Premium stainless-steel hardware and pin bushing kit for easy, problem-free installation.). Against stock calipers and pads, the case for this kit is quieter, lower-dust braking: the manufacturer says the Z23 line's rubberized shims provide virtually noise-free braking. Owners on user forums who moved to drilled and slotted rotors with ceramic pads on the Stinger have reported a clear gain over stock parts, often for less money than a dealer quote. Searchers looking for a 2018-2020 Kia Stinger front brake pad and rotor kit, carbon-fiber ceramic pads, or a drilled slotted rotor upgrade will find this kit matches those needs.
Installation is a front-axle pad and rotor job. Owners on user forums describe it as a manageable DIY task with a 21mm socket for the lug nuts and a 17mm socket for the caliper bolts, and they warn that the rotor retention Phillips screws strip easily Careful - they're often stuck and easy to strip the heads.. Forum users also recommend cleaning the anti-rust film off new rotors with brake cleaner before fitting, and compressing the caliper pistons to make room for the new pads. For torque, the manufacturer's service documentation lists the caliper mounting bolts at roughly 72 to 87 lb-ft and the caliper guide bolts at about 16 to 23 lb-ft, so verify these against your service manual. The manufacturer also recommends a break-in of 30 decelerations from 30 mph to 5 mph, with 30 seconds of cooling between each stop.
Most listings point to the 2018 to 2020 Stinger, but some sources extend fitment to later model years and V6 3.3L variants. Fitment details vary, so confirm your model year, trim, and engine with the manufacturer before ordering.
Per the manufacturer's Z23 product information, the kit includes stainless-steel installation hardware and a pin bushing kit.
Yes. The manufacturer's Z23 guidance calls for 30 decelerations from 30 mph to 5 mph with 30 seconds of cooling between each, and notes that a resin smell during the first hot stops is normal.
This is a front-axle pad and rotor swap that owners on user forums generally rate as a moderate DIY job with basic hand tools, a torque wrench, and a jack with stands. Plan for extra time on the caliper pistons and the rotor screws, and use high-temperature brake lubricant on the pad contact points as the kit recommends.