The PowerStop K7942-36 is a rear-axle Z36 Truck & Tow upgrade that pairs carbon-fiber ceramic pads with drilled and slotted rotors. The manufacturer recommends it for trucks, 4x4s, and SUVs that not only work hard, but play hard as well. The pads use a carbon-fiber ceramic low-dust formula, and the rotors are zinc plated to protect against rust and corrosion.
Compared with stock rear parts, the manufacturer positions this kit as severe-duty stopping power that still drives normally day to day. The cross-drilled and slotted rotors allow air to flow to the rotor and pad contact area, helping not only to cool the rotor, but also the pad and rotor contact patch. The manufacturer also says the pads are low-dust and fade-free to help on those long mountain descents. Premium stainless-steel shims provide better heat dissipation and virtually noise-free braking. Owners on user forums frequently point to Z36 kits as a step up for towing with larger tires.
Fitment is the first thing to verify. Published fitment years for this kit vary by source, so confirm your exact vehicle with the manufacturer before ordering. Owners on user forums say the JL brake code decides which caliper and rotor fit, and that a mismatched code will not fit. A dealer can look up the code from the last eight digits of the VIN. Once the right parts are on hand, this brake pad and rotor kit comes with everything you need, including premium stainless-steel hardware, for an easy, bolt-on installation. Look for Z36 Wrangler rear brake pads and rotors, towing brake upgrade, and JL carbon-fiber ceramic pad fitment when you compare options.
Owners on user forums say the brake code is set at the factory and can be looked up by a dealer using the last eight digits of the VIN. Forum members also report that the BR2 and BRY codes use different calipers, so a mismatched code will not fit.
Yes. The manufacturer says the break-in procedure is critical to brake performance. The goal is to lay down an even layer of friction material on the rotors.
The manufacturer states the kit includes premium stainless-steel hardware along with the pads and rotors, so no separate hardware purchase is needed for the bolt-on swap.
The manufacturer describes this kit as a quick, bolt-on job that requires no extra trips to the parts store. Plan on a standard rear brake job: lift and support the vehicle on jack stands, remove the wheels, and swap the rotors and pads. Before disassembly, owners on user forums recommend inspecting the old rotors for deep gouging or pulsing and checking the pad faces for glazing. Forum members also suggest applying brake grease to the back of the pads where they contact the caliper piston to reduce squeal. Confirm your brake code before you start, since a mismatch will stop the install. Finish by completing the manufacturer's break-in procedure.