Power Stop's Carbon-Fiber Ceramic compound is designed for a low-dust formula, and this K7084 rear kit pairs it with drilled and slotted rotors in the brand's Z23 Evolution Sport line for the Audi RS3. The result is a complete pad-and-rotor set for the rear axle, so the pads and rotors are matched rather than sourced separately. The pads are designed to combine with the drilled and slotted rotors for cooler, smoother operation.
Compared with stock hardware, the case for this kit is brake fade and everyday confidence rather than track-level ultimate stopping power. Owners on user forums who drive twisty roads hard say the car stops better and fades less after the swap, and one reports the drilled-and-slotted rotors and Z23 pads performed well for the money. The trade-off is durability in harsh conditions: other forum members in salt-belt regions report rust on rotors and calipers within about two years, so buyers in winter-salt climates should factor in corrosion.
Fitment details vary by model year and rear rotor type, so confirm your exact application with the manufacturer before ordering.
Yes. The manufacturer's break-in continues with five moderate stops from 35 mph to 5 mph in rapid succession without letting the brakes cool. After this, the manufacturer advises continuing to drive without heating the brakes excessively and without coming to a complete stop for about five minutes at moderate speed.
Owners on user forums describe using the Z23 pad as a low-dust daily setup, and one owner swaps in a separate track pad for track days. Forum members in salt-heavy regions warn the rotors do not hold up as well in winter conditions.
The manufacturer's general brake kit guide lists a caliper piston compressor or C-clamp, a jack and jack stands rated for the vehicle, wheel chocks, brake fluid specified in the owner's manual, and brake component lube as the core tools. Monitor the brake fluid reservoir while compressing the caliper pistons so it does not overflow. The guide also says to never work on an elevated vehicle held in place only by a hydraulic jack. Check the fluid level first, since the reservoir should start about half full.