Free Shipping on Orders Over $99  ·  No Code Needed

Power Stop 17-18 Audi RS3 Rear Z23 Evolution Sport Coated Brake Kit

*Photo may not represent actual product

The Power Stop CRK7084 is a rear brake kit for the Audi RS3 built around the brand's Z23 Evolution Sport pad line and Genuine GEOMET-coated rotors. Rotors are coated inside and out for maximum protection against rust. The kit is sold as one matched set of rotors, pads, and stainless-steel installation hardware, which avoids mixing mismatched parts from separate catalog listings.

A coated rotor is worth the premium over a plain pad swap or bare-iron rotors if the car sees wet roads, salt, or long stretches parked outdoors, where unprotected rotors surface-rust quickly. The break-in matters as much as the parts. The manufacturer calls for 30 decelerations from 30 mph to 5 mph after installation, and proper pad bedding helps reduce the risk of rotor warping. Searches for "RS3 8V rear brake kit," "Z23 Evolution Sport rear brakes," and "GEOMET coated rear rotors" usually lead to this kit.

  • Position: Rear
  • Rotor finish: Genuine GEOMET coating, applied inside and out
  • Rotor design: Chamfered and slotted
  • Pad line: Z23 Evolution Sport
  • Included: Rotors, Z23 Evolution Sport pads, stainless-steel installation hardware
  • Application: Audi RS3 (8V), listed for 2017–2020; confirm year against your VIN

FAQ:

Does this kit need a break-in before normal driving?

Yes. The manufacturer specifies 30 decelerations from 30 mph to 5 mph after installation, with about 30 seconds of cooling between stops. Avoid holding the pedal at a full stop while the rotors are hot, because the pad can imprint the rotor and may contribute to brake judder.

Are the rotors drilled or only slotted?

The manufacturer describes this Z23 Evolution Sport rotor as chamfered and slotted. Product listings from other sellers vary on whether the rotors are also cross-drilled, so confirm the rotor design with the manufacturer before ordering.

Installing it yourself

This is a bolt-on job for a home mechanic comfortable with rear disc brakes. The manufacturer's install guide lists a jack and jack stands, a caliper piston compressor or C-clamp, brake component lube, and the fluid specified in the owner's manual. Check for rotor retaining screws before pulling the rotor, and if rust has bonded it to the hub, tap both faces alternately with a mallet. Clean the hub mating surface with a wire brush, and wash the new rotor with mild soap and water before fitting it. Owners who have documented the RS3 rear job report that the electronic parking brake must be put into service mode with a scan tool before the pistons can be retracted. When pushing the pistons back, push slowly to avoid unsafe back pressure, and watch the reservoir so it does not overflow. Confirm lug and caliper bracket torque in the Audi service manual rather than relying on forum figures.

  • MPN: CRK7084
  • Manufactured by: PowerStop
  • Units per SKU: 1
  • In Stock: 1
Exclusive member pricing Free membership — sign in to see your price
Join Free →

$181.85

MSRP / List price
Member Price
Your price after signing in
$181.85
Only 1 left in stock — order soon
Add to Cart:
MPN
CRK7084
Manufacturer
PowerStop
Availability
Only 1 left
Ships Same Day
Order before 5pm PST and this product ships same day
Member Pricing
Easy Returns
Expert Support
Secure Checkout