The Power Stop Z23 Evolution Sport rear brake kit (K6107) is a rear-axle pad and rotor upgrade for the 2016 to 2018 Subaru Crosstrek. It is a matched set from Power Stop's own Z23 Evolution Sport line, so you are not mixing pads and rotors from different brands. The line also includes premium stainless-steel hardware for the install.
Stock Subaru rear brakes are the baseline to beat. Owners on user forums describe factory Crosstrek rotors developing a slight pulsation at about 20,000 miles, which is the wear a matched upgrade set is meant to outlast. A buyer weighing this kit against a budget pad-only swap should consider that the pads and rotors are engineered to work together. The manufacturer also stresses break-in: after installation, you run controlled moderate stops and then a cooling drive before normal use, and you should expect a resin smell as the pads heat up.
The kit is rear-only, so the front brakes stay stock. Model-year coverage is listed inconsistently across sources, so confirm your VIN, trim, and rear brake setup with the manufacturer before ordering. Crosstrek owners searching for a 2016 2017 2018 rear brake kit, a Power Stop K6107 install, or rear pad bed-in guidance will find the details below. Owners on user forums also report that Subaru's factory shims make new pads fiddly to seat, so plan extra time for that step.
Fitment information differs between sources, and the year range is not consistent. Confirm your model year, trim, and rear brake setup with the manufacturer before you order.
Yes. The manufacturer's guidance calls for a controlled break-in followed by a cooling drive. Avoid holding the pedal at a stop while the rotors are hot, because the manufacturer warns that this can imprint pad material onto the rotor and may contribute to brake judder.
Owners on user forums say Subaru's factory retainer shims keep the pads under constant tension. A new pad has to be guided carefully into the shims before it settles into place.
A rear pad and rotor swap is a common home-garage job that calls for a floor jack, jack stands, and basic hand tools. Work one side at a time so the opposite assembly stays intact as a reference. Support the vehicle on jack stands placed at the manufacturer's recommended lift points, never on a jack alone. Before you remove the old rotors, owners on user forums cite a 10 mm stock rear rotor thickness and an 8.5 mm service limit from the Subaru service manual. If your old rotors are near that limit, replacing them with the kit's rotors makes sense. Expect the shim fitting to take the most patience, confirm torque specs in the Subaru service manual, and complete the break-in afterward.