PowerStop's K8068 is a rear-axle brake upgrade built on the company's Z23 Evolution Sport system, which combines a carbon-fiber reinforced ceramic formula with drilled and slotted rotors. The manufacturer's rounded slots are designed to clear gas and debris from the pad contact surface. Owners on user forums who run their Mazda 6s on spirited street driving and autocross report a bit more effort than the factory brakes but very consistent performance with good fade resistance when hot. Not every owner notices a dramatic change, so buyers should expect a refinement over stock rather than a transformation. Shoppers searching for a low-dust 2016-2018 Mazda 6 rear brake upgrade, drilled and slotted rear rotors, or Z23 carbon ceramic pads will find this single part number covers the full rear axle.
Fitment is listed for 2016-2018 Mazda 6 rear axles, but published model-year coverage for this part number is not consistent, so confirm against your VIN and trim before ordering. Rear calipers on these cars use an electronic parking brake mechanism, and owners on user forums say the piston will not push back with ordinary tools until the EPB is placed in service mode. The manufacturer also notes that many rear pistons cannot be retracted with a C-clamp because they screw in and out, so plan your tooling before you start.
Yes. The manufacturer's procedure for pads paired with drilled and slotted rotors calls for 5 moderate to aggressive stops from 40 mph down to 10 mph without letting the brakes cool, followed by 5 moderate stops from 35 mph to 5 mph. Skipping this step can leave uneven pad deposits on the rotors, which may cause vibration and reduced braking performance.
Owners on user forums report that the electronic parking brake mechanism sits behind the piston and blocks it from being pushed back. They describe putting the EPB into service mode first, then retracting the piston. Confirm the procedure against the vehicle's service information before you attempt it.
The manufacturer states that the kit includes premium stainless-steel hardware and a pin bushing kit for installation.
This is a rear brake job on a car with an electronic parking brake, so it is more involved than a standard pad swap. Plan on a piston compressor or suitable tool rather than relying on a C-clamp alone, and use brake grease on the edges of the pad plates where they contact the caliper. The manufacturer advises cracking the caliper bleeder to relieve fluid during piston retraction, and recommends pumping the brake pedal several times after reassembly to seat the pads before checking the master cylinder reservoir. Because brakes are safety-critical, a home mechanic should be comfortable with EPB service procedures, and anyone unsure should have the job done by a qualified technician.