The Power Stop K7320 is a rear-axle Z23 Evolution Sport brake upgrade kit for the 2016-2018 Ford Focus. It pairs PowerStop's carbon-fiber ceramic Z23 pads with drilled and slotted rotors, stainless steel hardware, and hi-temp brake lubricant. The manufacturer describes the Z23 compound as a low-dust ceramic blended with carbon fiber, aimed at more stopping power than traditional ceramic pads without the noise or dust of harder performance pads. The drilled and slotted rotors are meant to work with the pads to keep brake temperatures lower during demanding stops. That makes this kit a practical step up from stock pads and rotors for a daily driver who also sees spirited back-road use or occasional track days. Owners on user forums report a softer initial bite that firms up as the brakes heat, plus noticeably less dust than stock setups.
Installation is a realistic weekend project for a home mechanic with a floor jack, rated jack stands, a caliper piston compressor or C-clamp, and brake fluid matched to the owner's manual. The manufacturer's install guide estimates roughly five hours and warns that rust can bind a rotor to the hub, sometimes requiring a mallet. The pistons must be pushed back to fit the thicker Z23 pads, and the caliper bracket bolts should be torqued to factory specification. Owners on user forums say the caliper slide bushings are the most frustrating part of the job, so set aside extra time for them. Once installed, bed in the pads and rotors with the manufacturer's stop sequence for a consistent, fade-resistant rear brake feel on your Focus.
The manufacturer says no, as long as the original caliper is in good working condition. The pads and rotors are designed to fit the factory caliper and mounting hardware.
The manufacturer recommends five stops from 40 mph to 10 mph without coming to a full stop between them, followed by five stops from 35 mph to 5 mph. Expect a resin smell during this process, then let the brakes cool by driving at moderate speeds without stopping.
Owners on user forums report that the caliper slide bushings were difficult to remove and reinstall, and at least one owner chose not to replace the bushings on the second side because they appeared to be in acceptable condition.
Owners on user forums have reported surface corrosion on PowerStop rotors after a couple of years in salt-heavy or winter conditions. Drivers in those regions should inspect the rotors regularly.
Plan on a few hours for a rear pad and rotor swap with a jack, rated jack stands, a caliper piston compressor or C-clamp, brake lubricant, and fluid specified in your owner's manual. Check for rotor retaining screws before pulling the rotor, and if rust has bonded it to the hub, tap it loose with a mallet. Clean the hub and rotor surfaces before reinstalling, and be ready for the caliper slide bushings to be the slowest step. Follow the manufacturer's bedding procedure after the first drive to get consistent pad transfer and quiet operation.