The Power Stop K7039-26 is a rear-axle kit from the brand's Z26 Street Warrior line. It comes with everything needed for installation, including pads, rotors and stainless-steel hardware. The manufacturer says its drilled and slotted rotors and carbon-fiber ceramic pads work together to shorten stops in severe conditions. That makes it a fit for a modified Subaru Legacy that has more horsepower, larger wheels, or occasional track days. Stock rear brakes are not designed for that repeated, high-heat use, so the upgrade is about fade resistance and consistent pedal feel, not just a cosmetic change. Buyers should expect a noticeable cost over basic replacement pads, so the decision depends on how hard the car is driven. Search terms this kit matches include Z26 carbon ceramic rear brake kit, drilled slotted rotor upgrade, and Subaru Legacy rear brake upgrade.
Proper bedding matters with this kit. The manufacturer calls break-in critical for optimal performance, starting with five moderate to aggressive stops from 40 mph down to 10 mph without letting the brakes cool. The manufacturer also notes that the purpose of break-in is to lay down an even layer of friction material on the rotors. Fitment should be verified before ordering. Published Legacy year ranges for this kit disagree, and the manufacturer's own page does not settle the question, so confirm your exact model year and trim before purchase. Rear pad changes on these Subarus also involve the electric parking brake system, which is covered in the install notes below.
The standard kit includes pads, rotors and hardware. The manufacturer offers a separate version with powder-coated calipers for buyers who want new calipers as well.
The manufacturer specifies a first stage of five moderate to aggressive stops from 40 mph down to 10 mph without letting the brakes cool or coming to a complete stop. A second stage follows with five moderate stops from 35 mph to 5 mph. Some resin odor during this process is normal.
Details vary. Owners on user forums report that the rear calipers use an electric parking brake motor. Some say an EPB service tool or a Subaru Select Monitor maintenance mode is needed to retract the piston, while others have done it with needle-nose pliers. Check your model's service information before starting.
Owners on user forums describe the rear job as a standard pad and rotor swap: remove the wheel, remove the caliper bolts, compress the piston, and reinstall. One owner reported about two hours for the rear, including rotors. A C-clamp is the common tool for pushing the piston back, with needle-nose pliers as an alternative. Because the rear uses an electric parking brake, the piston should not be forced back without confirming the correct procedure. Forum members also note that the pad with the butterfly clip goes on the inside position. Plan on a moderate difficulty level, and do the break-in procedure once the job is complete.