The Power Stop Z23 Evolution Sport front kit for the Ford Focus pairs carbon-fiber reinforced ceramic brake pads with drilled and slotted rotors and premium stainless-steel hardware. The manufacturer describes the Z23 compound as built for fade-free braking and cleaner wheels. Owners on user forums report noticeably less brake dust than stock pads and quieter stops, though a few say cold bite is softer than OEM until the pads warm up. This kit is a pad-and-rotor set without calipers, so you keep your existing calipers and avoid the cost of a full caliper upgrade. Searchers looking for a Focus front brake upgrade, carbon-fiber ceramic pads, or drilled and slotted rotors for daily driving will find this kit a practical match.
Fitment is the part to verify before ordering. Sources disagree on which Focus years and trims are covered, with some listings tying the kit to ST-specific front rotors and others listing 2015 to 2018 models. Confirm your exact year, trim, and VIN with the manufacturer before buying. Installation is a standard bolt-on job when the fitment matches, and the kit includes new pads, rotors, and hardware. Bed in the pads using the manufacturer's Z23 break-in procedure to get full performance and avoid glazing.
No. K7147 is the pad-and-rotor configuration without calipers, so it is intended to reuse your existing stock calipers.
Fitment information varies across sources. Some list 2014 to 2018 Focus models with ST-specific front rotors, while others list 2015 to 2018 models. Confirm the year, trim, and VIN with the manufacturer before purchase.
Yes. The manufacturer's Z23 break-in procedure calls for 30 decelerations from 30 mph to 5 mph, with 30 seconds of cooling between each stop. Some resin odor during the first hot stops is expected.
Owners on user forums commonly report much lower brake dust and quieter operation than stock pads. Some note that initial cold bite is softer than OEM until the pads warm up, and opinions vary on overall braking feel.
This is a front axle pad-and-rotor job that suits a home mechanic with basic tools and some experience. Plan on a jack, jack stands, a torque wrench, a C-clamp or caliper piston tool, and a fresh bottle of DOT 3 or DOT 4 brake fluid if the system needs bleeding. Check the caliper slide pins and pin bushings for corrosion before reassembly, and use the supplied hardware and lubricant rather than substitutes. Torque the lug nuts and caliper bolts to the manufacturer's specifications, and always verify fitment before you disassemble. If you lack the tools or confidence, a professional installer can complete the job.