The Power Stop K4713 is a front brake upgrade from the brand's Z23 Evolution Sport line. It pairs carbon-fiber ceramic pads with drilled and slotted rotors in one kit. The manufacturer says the low-dust pad formula was checked through third-party on-vehicle testing, so buyers who are tired of black wheel dust from stock pads get a measurable difference. Rubberized shims and a stainless steel hardware kit cut squeal, and zinc-plated rotors resist rust on a daily-driven SUV. Buying the pads and rotors separately from budget brands usually means piecing together compatible hardware yourself, which this matched kit avoids.
This kit is listed for the 2015 to 2017 Lexus NX200t in both Base and F Sport trims, and the manufacturer states that no modifications are needed for a bolt-on swap. A typical front job involves removing the wheel and caliper, replacing the rotors, installing the new pads with the included hardware, and applying the supplied high-temperature lubricant to the contact points. Clean the caliper bracket and slide pins before reassembly, torque the lug nuts properly, and pump the pedal before driving. Searches for a 2016 NX200t front Z23 brake upgrade, low-dust ceramic pads for a Lexus NX, and drilled slotted zinc rotor kit usually lead to this configuration.
No. The kit contains rotors, pads, hardware, and lubricant. The manufacturer also sells a separate Z23 Evolution Sport version that adds powder-coated calipers, so check the part number before ordering if you need calipers.
The manufacturer states the kit is a bolt-on upgrade that needs no modifications to the vehicle.
The manufacturer describes the rotors as zinc plated to help protect against rust and corrosion, while the drilled holes and slots are intended to help with cooling and dust clearing.
Fitment listings for other Lexus and Toyota models vary in their year ranges, and I could not confirm them against the manufacturer's fitment chart. Confirm your exact year, trim, and part number with the manufacturer before ordering.
This is a moderate-difficulty front pad and rotor job that suits a home mechanic with some experience. You will need a floor jack and jack stands, a socket set with a torque wrench, a C-clamp or piston compression tool, and a wire brush for cleaning the bracket. Keep the brake hose from straining when you move the caliper aside, and do not let the caliper hang from the hose. Clean the rotor hub mounting surface so the new rotor sits flat, and replace the clips and shims with the new hardware. Check the brake fluid level before pressing the pistons back, and pump the pedal until it firms up before driving. Bed in the new pads with gradual stops rather than hard braking right away.