The Power Stop K1601-26 is a rear axle brake kit for the 2005-2006 Pontiac GTO. It pairs Z26 carbon-fiber ceramic brake pads with drilled and slotted zinc-plated rotors. The manufacturer says its proprietary Z26 compound enhances heat dissipation versus a typical ceramic brake pad, which helps with fade on repeated stops. The pads are also built for low dust and quiet operation, so the rear wheels stay cleaner and the braking stays virtually noise-free. Owners on user forums note that the GTO's rear brakes do relatively little of the work because the car is so front-biased. That makes this rear kit more useful for matching a front upgrade, cutting rear dust, and improving consistency than for dramatically shortening stops. If you are searching for a 2005-2006 GTO rear brake pad and rotor kit, drilled slotted rotors, or a carbon ceramic street upgrade, this is the kit built for that job.
Fitment is the first thing to verify. Owners on user forums report that the GTO's rear pads are unique, so generic pads will not do. Forum discussions also indicate that the 05-06 rotors are vented unlike the solid 04's, so a 2004 GTO will not match this kit without additional parts. Installation is a bolt-on job for a home mechanic with a jack, jack stands, wheel chocks, a caliper piston compressor or C-clamp, and brake lubricant. The manufacturer's install guide says to apply a small amount of brake lube on the back of the pads where they contact the caliper, and to torque the caliper bracket and caliper bolts to the manufacturer's specifications. Because the kit includes a new pin bushing kit (where applicable), replacing the slide pin bushings during the job is worthwhile. Plan on a proper bedding procedure after installation to avoid judder and to build an even pad transfer layer.
This kit is listed for the 2005-2006 GTO rear axle. Owners on user forums report that the 2004 and 2005-2006 GTO rear brake components differ, including the rotor style, so confirm fitment with the manufacturer before ordering for a 2004 model.
According to the manufacturer, the standard Z26 Street Warrior kit includes pads, rotors, stainless-steel hardware, and hi-temp brake lubricant. The manufacturer offers a separate version with powder-coated calipers.
Yes. The manufacturer calls the break-in procedure critical to performance. It recommends making moderate stops from about 35 mph down to 5 mph in rapid succession without letting the brakes cool, and expects a resin smell during this process.
This is a rear-axle pad and rotor replacement suited to a home mechanic with basic tools. Gather a jack, jack stands, wheel chocks, a caliper piston compressor or C-clamp, brake lube, and a torque wrench. The manufacturer's guide advises checking the brake fluid level per the owner's manual and finishing the lug nut torque only after the vehicle is back on the ground. Watch for three common gotchas: do not twist the brake hose when reinstalling the caliper, clean the rotor hub surface before mounting the new rotor, and install the pin bushing kit rather than reusing worn bushings. Tighten the bracket and caliper bolts to the manufacturer's specifications, and perform the break-in procedure afterward.