The Power Stop Z26 Street Warrior front kit for the 2005-2006 Pontiac GTO pairs drilled and slotted rotors with carbon-fiber ceramic pads. The manufacturer recommends this Z26 Street Warrior upgrade kit for high performance, high horsepower muscle and modified cars. The drilled and slotted rotors and carbon-fiber ceramic pads are meant to work together to shorten stops under demanding conditions. Owners on user forums say the bigger 05-06 front rotor is the main gain over 2004 front brakes, and one owner who ran ceramic pads up front reported they were easy on the rotors. Compared with stock pads, this matched set is built for repeated hard stops rather than casual driving. The manufacturer supplies the pads, rotors, and stainless steel hardware needed for a front swap, and it also sells a separate version with powder coated calipers, so this base kit is meant for use with your existing calipers. Search terms this kit matches include 2005-2006 GTO front brake pads and rotors, Z26 carbon ceramic brake kit, and drilled slotted GTO front rotors.
Fitment is limited to the front axle of 2005-2006 Pontiac GTOs. Owners on user forums describe converting 2004 front brakes to 05-06 parts as a separate project, so confirm fitment with the manufacturer before ordering if your car is a 2004. The manufacturer's break-in step matters for this kit. Holding the pedal down while the rotors are hot can press a pad imprint into the rotor, which may contribute to brake judder. Break-in figures differ between the manufacturer's pad and kit pages, so follow the instructions included with your kit and confirm the procedure with the manufacturer before the first hard stops.
The manufacturer describes this version as pads, rotors, and stainless steel hardware. The calipers are offered only in a separate kit with powder coated calipers, so this one is for reusing your existing front calipers.
The kit is listed for 2005-2006 Pontiac GTOs. Owners on user forums describe moving 2004 fronts to 05-06 rotors and calipers as a separate conversion, so confirm fitment with the manufacturer before ordering.
The manufacturer calls break-in critical to brake performance. Its pad and kit pages give different break-in details, so follow the instructions included with your kit and confirm with the manufacturer if anything is unclear.
This is a front-axle pad and rotor swap that reuses your existing calipers, so plan for a full front brake job with the car safely supported on jack stands. Clean the new rotors before installing them, check rotor runout, and apply brake lubricant only where the pad contacts the caliper bracket, not on the friction surfaces. If you open a bleeder or loosen a line during the job, bleed the system afterward. Make sure the wear sensor sits on the correct inside pad. Bed the pads and rotors using the procedure in your kit and avoid holding the pedal down while the brakes are hot.