The PowerStop Z26 Street Warrior rear kit (K1563-26) pairs carbon-fiber ceramic pads with drilled and slotted cast rotors for the rear axle of the 2004-2009 Cadillac XLR. The manufacturer recommends the Z26 kit for high performance, high horsepower muscle and modified cars. Its pad compound is designed to shed heat better than a typical ceramic pad, which helps it hold stopping force when the brakes get hot. The zinc plating provides long-lasting protection from rust and corrosion. That matters on the XLR, since owners on user forums describe rotor centers and vanes rusting badly and dripping rust water onto the wheels.
Because the kit is a bolt-on design, you can keep the factory calipers. The manufacturer says you do not need to change calipers as long as the original is in good working condition. Owners on user forums note that the XLR rear uses a single piston on one side, and they advise against forcing the rear piston back with a clamp. The piston screws back into the caliper to line up with the new pad, so use a brake cube or needle-nose pliers instead of clamping force. If you're searching for a 2004-2009 XLR rear brake upgrade, drilled rotors, or a street performance ceramic pad kit, this one is built for daily-drivable stopping power rather than track duty.
The manufacturer states that the pads and rotors are designed to fit the existing caliper and mounting hardware, so the original calipers can stay if they are in good working condition. Powder-coated caliper versions of the Z26 are sold separately by the manufacturer.
The manufacturer positions the Z26 for high-horsepower street and modified cars. Owners on user forums point out that pads built to run hotter on track don't perform as well in everyday street use, so a street-oriented compound is the better match for most XLR owners.
According to the manufacturer, the kit includes pads, rotors, stainless-steel hardware, and a pin bushing kit. The pads use stainless-steel shims.
The manufacturer describes this as a bolt-on upgrade with the hardware included, so it does not require modifying the brake system. Owners on user forums warn that the rear caliper piston must be wound back carefully because it is part of the parking-brake adjustment system; forcing it can cause problems. Use a brake cube or needle-nose pliers, and check the parking brake once the job is finished.