The Power Stop K1563 is a rear-axle upgrade from the manufacturer's Z23 Evolution Sport line, pairing drilled and slotted rotors with ceramic pads that the manufacturer says are reinforced with carbon fiber. It is built for daily-driven 2004-2009 Cadillac XLR owners who want better stopping without track-only compounds. The manufacturer also supplies stainless-steel hardware and a pin bushing kit, so the rotors, pads, and fasteners arrive matched. Listed model years differ between sources, so confirm your VIN-specific application before ordering.
Stock rear rotors are a weak point in salt-belt climates. Owners on Cadillac forums describe factory rotors rusting at the fins and edges, which makes a zinc-protected, drilled-and-slotted replacement a practical upgrade. The rear calipers on the XLR are single-piston, single-side units, so the pad and rotor pairing matters for fade resistance and pedal feel. Choosing a low-dust carbon-ceramic compound also keeps fancy wheels cleaner than a standard organic pad. For a rear axle, the Z23 kit is a focused way to improve braking without the cost of a full big-brake conversion.
The manufacturer states that break-in is critical to brake performance because it deposits an even layer of pad friction material onto the rotor surface. Follow the manufacturer's break-in procedure after installation so that layer forms evenly.
Owners on Cadillac user forums report that rear caliper pistons screw back into the caliper rather than pressing straight in, and that the piston is part of the parking brake adjustment. They advise using a brake tool or needle-nose pliers to turn the piston rather than forcing it with a clamp.
This is a rear-axle job for an experienced home mechanic with a jack, jack stands, a lug wrench, a wire brush, a brake tool or C-clamp, and a torque wrench. Loosen the lug nuts before lifting, support the car on stands placed at the manufacturer's recommended points, and remove the wheel. Clean rust and dust from the caliper bracket and sliding surfaces, then apply brake lubricant only to the metal contact points, never the pad friction surface. Owners on user forums describe the rear pad change as taking roughly 30 to 45 minutes per side. Pay close attention to the parking brake adjustment and the rear piston, and bed in the new pads according to the manufacturer's break-in steps.