The PowerStop K4583 is a rear brake pad and rotor kit from the manufacturer's Z23 Evolution Sport line, pairing carbon-fiber ceramic pads with drilled and slotted rotors for daily driving. The Z23 Evolution Sport Brake Upgrade Kit is positioned as an easy, affordable performance upgrade for the daily driver. The manufacturer also sells a separate Z23 version with powder-coated calipers, so this rear kit covers pads and rotors only. Fitment depends on the vehicle, so confirm your application before ordering.
Compared with stock pads, the manufacturer says the Z23 compound reduces brake dust, which helps wheels stay cleaner between washes. The drilled and slotted rotors are meant to run cooler and resist rust, and the rotors are zinc plated for corrosion protection. Owners on user forums report that dust drops noticeably after bedding, though results vary. Rubberized shims are included to reduce brake noise. For a buyer comparing rear brake kit upgrades for a Chrysler 300, Z23 carbon-fiber ceramic pads with drilled and slotted rear rotors are a practical daily-driver choice.
No. This K4583 is a pad and rotor kit. The manufacturer offers a separate Z23 Evolution Sport kit that includes powder-coated calipers, so check which version you are ordering.
Yes. Owners on user forums advise following the break-in instructions, since skipping them can reduce how well the pads perform.
Fitment varies by model year, trim, engine, and front caliper type across Chrysler 300 and related Dodge applications. Match your vehicle's year, trim, engine, and caliper casting against the application data before ordering.
The manufacturer's brake kit installation guide lists a jack and jack stands rated for the vehicle, wheel chocks, brake fluid, brake component lube, and either a caliper piston compressor or a C-clamp, and recommends safety glasses and gloves. Check the brake fluid reservoir before you start; the guide says it should sit about half full, and you should watch it while compressing the caliper piston. The guide also describes removing the two caliper guide pin bolts and supporting the caliper with a hanger or wire, not by its hose. The manufacturer directs installers to the vehicle service manual for complete procedures, so use that alongside the kit, and complete the bedding procedure on the new pads afterward.