The Power Stop K2427 is a rear-axle kit from PowerStop's Z23 Evolution Sport line, pairing Drilled & Slotted rotors with carbon-fiber ceramic pads. The manufacturer describes the pads as a low-dust formula and says the pairing gives a cool, smooth ride. Compared with stock rear pads and rotors, the appeal is a more capable braking setup for a daily-driven FX35 that still keeps wheel dust and noise down. The kit is listed for the 03-12 Infiniti FX35, though the year range published for this kit varies, so confirm your VIN with the manufacturer before ordering.
Performance depends on bedding, so budget time for the break-in. The manufacturer explains that the break-in establishes an even layer of friction material deposited on the rotors from the brake pads, and expects some resin odor during the process. Searchers looking for an FX35 rear Z23 carbon ceramic kit, drilled and slotted rear rotors, or an FX35 brake bedding procedure will find the key points here. Following the manufacturer's break-in steps is what turns a bolt-on swap into a noticeable improvement over factory parts.
Yes. The manufacturer's first step calls for five moderate-to-aggressive stops from 40 mph down to 10 mph in quick succession without fully stopping, followed by five moderate stops from 35 mph to 5 mph, then a cool-down drive.
Yes. If you are forced to stop, complete the stop and shift into park or leave room to roll slightly, because holding the pedal down while the rotors are very hot can imprint the pad onto the rotor. The manufacturer notes that such an imprint may contribute to brake judder.
The manufacturer's install guide warns that this can cause damage to the brake hose. Support the caliper on a hanger or wire during the job.
Before starting, the manufacturer's install guide says to check that the brake fluid reservoir is about half full and to use fluid matching your owner's manual, along with brake component lube. Remove the caliper and support it, then clean any rust off the face of the hub mating surface with a wire brush and a hub cleaning kit. The guide also recommends installing new hardware, since worn or damaged hardware can lead to noise or poor pad performance. When mounting the caliper bracket, torque the caliper bracket bolts to the manufacturer's specifications. Keep lube off the friction side of the pads, and make sure not to twist the brake hose when reinstalling the caliper. Confirm torque values in your service documentation before final assembly.