The Power Stop K2427-26 is a rear-axle upgrade built on the brand's Z26 Street Warrior line, pairing carbon-fiber ceramic pads with drilled and slotted rotors for the Infiniti FX35. The manufacturer recommends the Z26 Street Warrior kit for high performance, high horsepower muscle and modified cars. Its carbon-fiber reinforced ceramic pads are rated to resist fade up to 1500 degrees. The pads are described as an upgrade over stock brakes that reduces brake dust and eliminates noise. Owners on user forums report that the dust reduction is real but that low-speed squeal and pad life vary, so set expectations accordingly.
Why pay more than for a basic pad-and-rotor set? This kit arrives as one matched package. It includes pads, rotors and stainless-steel hardware for installation. The manufacturer also supplies premium stainless-steel hardware along with ceramic brake lubricant, which saves a separate parts run. Owners on user forums say the drilled and slotted rotors hold up well with no cracking or warping after extended street use. Because the manufacturer sells a separate version with calipers, this kit is the lower-cost option for owners whose rear calipers are still in good condition.
Fitment is the main variable. Published model-year ranges for the FX35 differ between listings, so confirm your year and trim with the manufacturer before ordering. Owners on user forums report that rear rotors can seize to the hub from rust, and penetrating oil usually loosens them. Searches for Infiniti FX35 rear brake pads and rotors, Z26 carbon ceramic pads, drilled and slotted rotor upgrade, and FX35 rear brake kit DIY tend to surface this exact application.
No. The manufacturer lists this Z26 kit as including pads, rotors, and stainless hardware. A separate manufacturer kit adds calipers, so check which version you are ordering.
The manufacturer's install guide calls for a caliper piston compressor or C-clamp, but it warns that many rear brake pistons cannot be retracted with a C-clamp because they screw in and out. Plan to turn the piston as well as press it.
The manufacturer states the pads are designed to reduce dust and eliminate noise compared with stock. Owners on user forums report less dust than stock but occasional low-speed squeal, and some note that pads can rust onto the rotors if the car is washed and not driven soon afterward.
This is a standard rear pad-and-rotor job with caliper removal. The manufacturer's guide lists brake fluid as specified in your owner's manual, brake component lube, a piston compressor or C-clamp, jack stands rated for the vehicle, and wheel chocks. It also advises checking that the reservoir is about half full, and watching the level as you retract the piston. Owners on user forums describe the rear rotor hub fit as snug, so a light coat of penetrating oil helps. If the rotor will not come off, check for the parking-brake shoe adjuster behind the rotor, since owners report it can hold the rotor in place. Clean the hub face and use the stainless hardware and lube included in the kit. Bleed the brakes only if you open the hydraulic system.