The PowerStop K5337-36 is a rear-axle brake upgrade for the 2001-2006 Chevrolet Silverado 3500. Its pads use the manufacturer's Z36 carbon-fiber ceramic compound, which the company says is reinforced to handle heavier loads than a typical ceramic pad. The kit pairs those pads with drilled and slotted rotors, which the manufacturer says provide better rotor cooling. Stainless-steel hardware and hi-temp brake lubricant are included, so you can complete the job without sourcing extra parts. Owners on user forums report a clear gain in stopping confidence when pulling a trailer, and one owner noted less brake dust than the stock pads. Stock brakes are adequate for light use, so this kit makes the most sense for buyers who tow, haul, or drive steep grades with a Silverado 3500 rear axle. Searches for "Z36 rear brake kit 2001-2006 Silverado 3500," "carbon ceramic towing brake pads," and "drilled slotted rear rotors heavy duty truck" will find this part.
The manufacturer describes the kit as an easy bolt-on upgrade with premium stainless-steel hardware and a pin bushing kit for problem-free installation. Owners and installers should still follow the manufacturer's procedure for caliper bracket and pin service.
Yes. The manufacturer states that the break-in procedure for new pads and rotors is important for optimal braking, quieter operation, and longer service life.
No. Based on its listed position, this part number covers the rear axle only. Front components must be purchased separately.
The manufacturer's brake kit install guide lists a caliper piston compressor or C-clamp, brake fluid, brake component lube, a jack, and jack stands rated for the truck's weight among the tools needed. Chock the front wheels, set the parking brake, and loosen the lug nuts before lifting the rear. Check that the brake fluid reservoir is about half full, then remove the caliper and hang it with a hanger or wire so the hose is not stressed. Push the piston back slowly while watching the reservoir, because rushing it can cause back pressure that damages the ABS modulator, brake valving, or master cylinder. The guide also notes that many rear pistons screw in and out and cannot be retracted with a C-clamp, so check the piston type before you start. Finish with the manufacturer's break-in procedure, and consult the vehicle's service manual for torque specs and any bleeding steps.