The Power Stop K2323 is a front Z23 Evolution Sport kit that pairs carbon-fiber ceramic brake pads with drilled and slotted rotors, and the manufacturer positions it for daily driving with occasional hard use. The manufacturer's listing ties it to the 2001-2002 Toyota Sequoia and 2000-2002 Toyota Tundra when the front calipers carry casting S13WE. The kit includes stainless-steel hardware, a pin bushing kit, and high-temperature brake lubricant, so it covers the full front axle job without sourcing parts separately. Compared with stock pads and rotors, the manufacturer claims higher braking power, lower brake dust, and better heat management from the drilled rotors under hard braking, which is the real-world reason to pay for a bundled upgrade over a basic replacement set. The manufacturer's 36-month/36,000-mile warranty adds confidence, and it covers rotor cracking but excludes disc thickness variation. Search terms this kit targets include 2001 Sequoia front brake upgrade, 2000 Tundra ceramic brake kit, drilled slotted rotor kit, and low dust carbon ceramic pads.
Before ordering, confirm the caliper casting number, because owners on user forums say S13WE is stamped on the inner side of the caliper and the larger 13WL casting needs a different kit. Installation is a bolt-on job that uses the included stainless hardware and pin bushings, with no modifications required according to the manufacturer. Once installed, the manufacturer's break-in procedure calls for a series of firm stops from about 40 mph to 10 mph, followed by moderate stops from 35 mph to 5 mph, with cooling time between sets. Expect a resin smell during this process, which is normal according to the manufacturer.
The manufacturer lists K2323 for the front of 2001-2002 Sequoia and 2000-2002 Tundra models with caliper casting S13WE. Owners on user forums advise checking the casting number stamped on the inner side of the caliper before ordering, since the larger 13WL casting is a different fit.
Yes. The manufacturer's break-in procedure involves a set of firm stops from about 40 mph to 10 mph followed by moderate stops from 35 mph to 5 mph, with cooling between sets. Skipping it can leave an uneven layer of pad material on the rotors.
The manufacturer warrants the kit for 36 months or 36,000 miles from purchase, whichever comes first. The warranty includes rotor cracking but excludes failures caused by disc thickness variation, which usually shows up as brake pulsation, and excludes normal wear.
This is a bolt-on front brake job that the manufacturer says needs no modifications and includes stainless-steel hardware and pin bushings. Plan on a floor jack, jack stands rated for the vehicle, a C-clamp for pushing the caliper piston back, and brake fluid if you open the hydraulic system. Confirm the S13WE casting before you start, because the wrong caliper fit is the most common reason this kit won't work. Use the included high-temperature lubricant only on the sliding contact points of the pad hardware and keep it off the friction material. Once the wheels are back on, complete the manufacturer's break-in sequence before any spirited or towing use.