Free Shipping on Orders Over $99  ·  No Code Needed

Power Stop 21-23 GMC Yukon XL Front Semi-Coated Rotor Kit

*Photo may not represent actual product

The Power Stop SC8172 is a front rotor kit for the GMC Yukon XL, built on the manufacturer's semi-coated rotor design. The rotor is coated for corrosion resistance on the hat, outer edges, and vanes, and the surface that contacts the pads is cross-hatched to help pads bed in. Buyers searching for a semi-coated GMC Yukon XL front rotor upgrade or an OE-style bolt-on brake rotor are looking for this kind of setup.

The case for paying more than a bare replacement rotor is rust control on the surfaces that corrode first. Weight and vane count match the original design, so cooling airflow and balance stay close to factory. Since the coating is limited to the hat, edges, and vanes, the friction face stays clean for pad contact, and the hat-to-rotor contact area is where the protection matters most for hub-mounted rust.

Fitment year coverage is not consistent across sources, so confirm your Yukon XL's model year, trim, and caliper configuration with the manufacturer before ordering. Swapping the rotor means removing the caliper and its bracket, so plan for a jack, stands, and basic hand tools. Plan a deliberate pad bedding routine after installation, since the manufacturer's break-in guidance for its performance kits warns that hot rotors can imprint and cause judder if the pedal is held down.

  • Part Number: SC8172
  • Position: Front
  • Vehicle: GMC Yukon XL (2021–2023 per product name; confirm year coverage with the manufacturer)
  • Rotor Coating: Semi-coated on hat, outer edges, and vanes
  • Friction Surface: Cross-hatched for pad break-in
  • Weight and Vane Count: Matches original equipment design
  • Installation: Direct bolt-on, no modifications needed

FAQ:

Does the semi-coating mean the whole rotor is protected from rust?

No. The manufacturer applies its coating only to the hat, outer edges, and vanes, which it identifies as the areas most at risk of corrosion. The pad-contact surface is left with a cross-hatched finish rather than the coating.

Does this kit require a special break-in procedure?

The manufacturer's break-in guidance for its Z23 performance kit says rotors run very hot, and holding the pedal down can imprint the rotor and contribute to judder. Confirm with the manufacturer whether the same routine applies to the SC8172 before following it.

Installing it yourself

Because the kit is a bolt-on replacement, the rotor swap follows the standard front brake job: lift the vehicle on stands, remove the wheel, detach the caliper and its bracket, and replace the rotor. Clean the hub mounting face before fitting the new rotor, and check runout if you notice pulsation after installation. Bed the new pads using the break-in routine above, and avoid holding the pedal down while the rotors are hot. Vehicle-specific torque values and caliper bolt sizes were not confirmed from the manufacturer during research, so use the manufacturer's install sheet or a service manual for those figures.

  • MPN: SC8172
  • Manufactured by: PowerStop
  • Units per SKU: 1
  • In Stock: 1
Exclusive member pricing Free membership — sign in to see your price
Join Free →

$284.23

MSRP / List price
Member Price
Your price after signing in
$284.23
Only 1 left in stock — order soon
Add to Cart:
MPN
SC8172
Manufacturer
PowerStop
Availability
Only 1 left
Ships Same Day
Order before 5pm PST and this product ships same day
Member Pricing
Easy Returns
Expert Support
Secure Checkout