This Power Stop Z17 Evolution kit pairs low-dust ceramic pads with fully coated rotors for both axles, so a single purchase covers the front and rear of a Trailblazer. The rotors carry the manufacturer's Evolution coating, which guards against rust, and the pads use layered rubberized shims to damp noise. The kit is built as a stock-style upgrade rather than a track compound, so it suits daily driving. Compared with buying pads and rotors separately, the coated rotors and included stainless-steel hardware bring the job to one order. Fitment is listed for the 2021 to 2022 Chevrolet Trailblazer, but year and trim coverage varies across sources, so confirm your exact model before ordering. Searches for a Trailblazer 2021 Z17 rear brake kit or Power Stop coated rotor upgrade will lead to this kit.
Plan on bedding in the new pads and rotors before normal use. The manufacturer's procedure calls for 30 decelerations from 30 mph to 5 mph, with 30 seconds of cooling between each stop, and it warns that a resin smell is normal as the brakes heat up. Owners on user forums report that the electric parking brake complicates the job, because the caliper piston will not retract easily while the parking brake is engaged. Putting the parking brake into service mode first, while the wiring remains connected, is the workaround they describe. You will need a caliper piston compressor or large C-clamp, fresh brake fluid, brake lube, wheel chocks, and a jack with stands. The manufacturer's install guide lists roughly five hours for a full front and rear job.
Yes. The manufacturer calls for 30 decelerations from 30 mph to 5 mph with 30 seconds of cooling between stops, and it says the rotors will get very hot, so avoid holding the pedal down while stopped.
Owners on user forums suggest putting the electric parking brake into service mode before retracting the caliper, and note that this only works while the parking brake's wiring stays connected.
No. The manufacturer warns that cooling the brakes with water can damage them, so let them cool naturally.
Follow the manufacturer's order of operations: check the brake fluid level, remove the caliper and support it without letting it hang from the hose, compress the piston with a C-clamp using an old pad to protect the face, clean the hub, then install the bracket, pads, and rotors with the included hardware. Lightly lube the pad ears and caliper contact points, and keep lube off the friction surfaces. Bleed the system if the pedal feels soft afterward. Because the Trailblazer uses an electric parking brake, plan extra time for the piston retraction step, and do the bedding procedure immediately after the install.