PowerStop's Z36 Truck & Tow front kit, part CPK2152-36, pairs carbon-fiber ceramic pads with fully coated, drilled and slotted rotors for the 1999-2001 Jeep Cherokee XJ. The pads use a low-dust compound reinforced with carbon fiber, which the manufacturer positions for heavier loads like trailers, loaded beds, and larger tire setups. Stainless steel shims are included to reduce noise. For a Cherokee owner who tows, hauls, or runs long mountain grades, the drilled and slotted rotors help dissipate heat during repeated hard stops, and the zinc plating helps protect the rotor surfaces from rust. The result is a front brake upgrade that targets fade and rust problems that stock components often show under sustained load, rather than a simple pad swap. Search terms this kit fits include 1999-2001 Cherokee XJ front brake upgrade, Z36 carbon ceramic pads, Jeep XJ towing brake kit, and drilled slotted rotor kit.
Fitment within this model range is not one-size-fits-all. Applications can vary by rear drum size and front rotor type, so confirm your configuration with the manufacturer before ordering. User forums consistently recommend measuring your existing rotors and comparing them to the replacement, since rotors can be machined to different dimensions. Installation is a standard front disc job: a floor jack, jack stands, a C-clamp, and 14mm sockets cover most of it. The kit includes stainless-steel hardware and a pin bushing kit for a bolt-on install. Plan on proper bedding afterward, and follow the manufacturer's break-in procedure to help prevent rotor warping.
Fitment depends on your specific configuration. Applications can vary by rear drum size and front rotor type, so confirm your vehicle's setup with the manufacturer. User forums recommend measuring your current rotors and comparing them to the replacement before purchase.
Yes. The manufacturer says following its break-in procedure is important, and proper pad bedding can prevent rotor warping. Avoid holding the brake pedal down while the rotors are hot, since this can imprint the pad onto the rotor.
User forums generally recommend replacing pads and rotors together, since the two wear as a matched system.
User forums describe this as a job within the reach of a regular home mechanic. Gather a floor jack, jack stands, a C-clamp to compress the caliper pistons, and 14mm sockets for the caliper bolts. Support the caliper with a wire hanger so it does not hang by the brake line, and clean and lubricate the caliper bridge and slides before reassembly. Inspect the hub and rotor surfaces, since rust can make a rotor bind. Bleeding the brakes is typically needed only if a caliper is replaced. Once installed, bed in the pads per the manufacturer's procedure before any heavy towing or spirited driving.