The Wilwood 140-10206-R is a rear combination parking brake (CPB) kit with red powder-coated calipers and 11-inch two-piece rotors. Combination hydro-mechanical Parking Brake calipers use hydraulic pressure from the master cylinder for stopping power, and an internal mechanical lock within the caliper for a parking brake. The kit's pads are BP-10 compound, seated in a D340 pad plate. The manufacturer notes that CPB kits are built primarily for front wheel drive vehicles, which suits a front-drive Civic. Choosing this kit over a generic rear disc conversion gets you a handbrake that works through the caliper, not a separate shoe system that often fits poorly on these cars. For Honda Civic and Acura Integra owners who want a bigger rear disc with a real parking brake, the kit covers both needs. Search terms: Honda Civic rear big brake kit, Integra CPB rear conversion, 11 inch rear rotor 2.39 hub offset, red caliper rear brake kit.
Fitment is set by the hub. The kit lists a 2.39 axle offset, radial mount, an 11.00-inch rotor, and a 15-inch minimum wheel diameter. Fitment years and trims are not confirmed by the manufacturer in this research, so check them against your vehicle before ordering. The kit does not include everything. The listing calls for line kit 220-10840 and parking brake cable 330-10966. Wilwood rear brake kits are not supplied with parking brake cable hardware or adapters. Plan for cable routing: bends in the cable can significantly reduce efficiency and thus reduce pull force at the brake. The manufacturer also says cables should be pre-stretched by repeated handbrake applications, then readjusted.
No. The manufacturer's kit documentation says rear kits are not supplied with hydraulic lines, and that parking brake cable hardware and adapters are sold separately. The manufacturer's listing pairs the kit with line kit 220-10840 and parking brake cable 330-10966.
The manufacturer lists a minimum wheel diameter of 15 inches for this kit.
According to the manufacturer's kit description, the pads are BP-10 compound, mounted on a D340 pad plate.
Wilwood's assembly sheets say installation should be done by someone experienced with disc brake systems. Start by raising the rear of the vehicle and supporting it per the vehicle maker's instructions. The manufacturer's cable instructions say to slide the clevis over the parking lever and secure the cable stop bracket with the supplied lock nut. Its guidance also recommends anti-seize on aluminum nuts. Route the cable to trace the original path, keep bends gentle, and use clamps to keep it clear of the exhaust and suspension. Owners on user forums commonly report that the cable hookup to the existing parking pedal or lever is the hardest step, so confirm your cable fitment before you tear anything down.