The Wilwood 140-10885-DR is a complete rear brake kit built on the company's combination parking brake (CPB) platform. Wilwood's 140-10885-r Mini Cooper CPB kit features red CPB hydro-mechanical calipers coupled with oversized 11.75" two-piece rotor assemblies with aluminum hats and high friction BP-10 compound pads. Hydraulic pressure handles service braking, while an internal mechanical lock inside each caliper provides the parking function. The CPB design is built primarily for front-wheel drive and select rear-wheel-drive vehicles whose axles are not well suited to internal shoe-style parking brakes. The manufacturer also says the kit provides the correct balanced brake performance and matching style to compliment your front big brake kit.
Fitment is the first thing to confirm. The manufacturer's kit summary lists a radial caliper mount, an axle offset of 0.00, and a minimum wheel diameter of 17 inches, so 17-inch wheels are required. Listings for Mini Cooper model years differ, and the manufacturer directs buyers to verify fitment on the Wilwood website before ordering. The manufacturer's configuration notes also show a line kit needed (220-10879), and the parking brake cable is sold separately, so budget for both.
Yes. The manufacturer lists 17 inches as the minimum wheel diameter for this rear kit, so smaller wheels will not clear the 11.75-inch rotor and caliper.
No. The manufacturer's configuration notes list line kit 220-10879 as a separate purchase, and the parking brake cable is also sold separately.
The manufacturer's fitment tool is the authoritative source. Published year ranges vary between sources, so confirm your exact year, body style, and wheel size with the manufacturer before ordering.
The manufacturer's install sheets for its CPB rear kits state that installation should only be performed by persons experienced in the installation and proper operation of disc brake systems. Check that the rotor sits flush against the axle flange or excessive rotor run out may result. If your axle studs are larger than 0.50", the manufacturer advises that a machine shop may need to drill the bolt circle of the hat/rotor to the correct stud size. Parking brake cables should be routed as straight as possible, since tight bends must be avoided with a minimum recommended bend radius of 6" to 8". Keep cables clear of exhaust and moving suspension, and use anti-seize lubricant on all aluminum nuts.