Wilwood's 140-10208-DR is a rear brake conversion kit built around an 11.00-inch drilled rotor and Wilwood's Combination Parking Brake caliper, so one caliper handles both service braking and the parking function. It is made for Honda Civic and Integra cars that left the factory with rear drum brakes and a 2.46-inch hub offset, and the manufacturer ties the kit to that drum and offset combination. Compared with factory drums, a disc setup like this is a common route for drivers wanting more consistent rear stopping on track days or autocross, and the drilled rotor and red finish make the upgrade visible. Model-year and trim coverage varies, so verify your exact car before ordering.
Owners on user forums report that the parking-brake side takes the most fiddling: the cable must be routed cleanly and the internal drum adjuster set so the caliper's mechanical lock engages. The factory parking cable will not adapt to the Wilwood caliper, so budget for a separate universal cable kit. The manufacturer also notes that OEM rubber brake hoses generally cannot be adapted to Wilwood calipers, which makes steel-braided lines with steel adapter fittings the usual approach. Shoppers searching for a Civic rear big brake kit, an Integra drum-to-disc conversion with parking brake, or a 2.46 hub offset 11-inch rear kit will find this part's specifics here.
The manufacturer specifies this kit for applications with original drum brakes and a 2.46 hub offset. If your car has rear disc brakes or a different hub offset, confirm the correct kit with the manufacturer before ordering.
The manufacturer states that the original equipment cable will not adapt to Wilwood calipers. A universal parking brake cable kit is sold separately, and the manufacturer's instructions direct you to follow that kit's own installation sheet.
The manufacturer notes that OEM rubber brake hoses generally cannot be adapted to Wilwood calipers. Its preferred method uses steel adapter fittings with enough steel-braided line to allow for suspension travel.
This is a moderate-difficulty job best suited to someone comfortable with disc brake systems, which is how the manufacturer describes the installation requirement across its rear kits. Expect to remove the factory drum assembly down to the bare axle and remove the stock bearing retainers before mounting the new bracket and caliper. Owners on user forums warn that cable routing and drum adjustment are the usual trouble spots, so set the adjuster and test the parking brake on a slight slope once the pads are bedded. Confirm the cable kit and hose fittings before you start so the job is not interrupted mid-install.