The Wilwood Forged Narrow Superlite 6R left-hand caliper in black is part of the FNSL6R radial-mount family, a forged aluminum six-piston caliper for big-rotor brake setups. The manufacturer describes a differential bore layout, with one 1.62-inch piston and two 1.12-inch pistons, that is meant to load the pads evenly under sustained heat. Owners on user forums say the narrow body is the version to choose when wheel clearance is the limiting factor, and that the wider Superlite is the better pick when pad life and rigidity matter more. Long-tail searches for a Wilwood 6 piston narrow radial caliper, LH black, 1.62/1.12/1.12 bore, 7416 pad, or 14 inch rotor clearance should land on this exact part.
Fitment is built around a 5.98-inch mount center and a rotor width of 1.25 inches with a 14.00-inch diameter, per the manufacturer's listing. The caliper is one piece of a bracket-based system, so brackets, brake hoses, and fittings are separate purchases, and owners on user forums warn that OEM lines will not adapt. Pads run on the 7416 pad family, which has several compound options, so confirm the compound you want before ordering. Plan for alignment shimming and a careful install, as covered below.
Owners on user forums report that brackets and brake hoses must be sourced separately, and the manufacturer's kit instructions state that OEM brake lines will not adapt to Wilwood calipers.
Owners on user forums say the narrow body can clear certain wheels where the wide Superlite cannot, but clearance varies by wheel offset, spacer, and rotor size. Measure before ordering.
The manufacturer lists the 7416 pad family with several compounds, so choose the compound that matches your use and confirm the pad part number against the manufacturer's pad chart.
This is a bracket-mounted job rather than a simple caliper swap. The manufacturer's Superlite 6R kit instructions call for shimming the bracket to square it against the spindle, then centering the rotor in the caliper opening by adding or removing shims in equal amounts on both mounting bolts. Once alignment is correct, the bracket bolts are secured with red Loctite 271 and tightened to the torque in your bracket's instructions, since values vary by kit. Because this is a left-hand unit, confirm the orientation: the kit instructions say left and right calipers must be mounted in a specific direction, with the largest piston at the rotor exit end. Check that the pad top sits flush with the rotor's outer diameter, and fit new lines rather than reusing OEM hoses. Owners on user forums say Wilwood's two-piece bleeder design lets you loosen the steel nipple without turning the aluminum body, which helps avoid damage during bleeding. Expect a more involved install than a stock swap, since bracket fitment and alignment are the main work.