This right-hand Wilwood MC4 mechanical caliper in black (120-12069-BK) is a self-contained, cable-pulled parking brake unit with a 1.19-inch piston, meant for 0.81-inch rotors. The manufacturer describes the MC4 as diecast and forged aluminum calipers with a steel mounting bracket, and lists the family at about three pounds, which keeps added rear-end weight low. Compared with a generic cable setup, the lever cartridge can be clocked in three positions for optimum positioning and ease of cable routing. Pad compound details vary across sources, so confirm the exact pad material with the manufacturer before ordering.
Wilwood's own kit instructions list 120-12069/70-BK in rear parking brake applications, including a rear Pro-Street kit with Dynalite caliper and 12.19" diameter rotor, a Chevrolet 12 bolt C-clip eliminator setup, and a 2006-2015 Mazda Miata kit. For track-day and drag builds where a hydraulic caliper alone cannot hold the car, this caliper offers a dedicated mechanical hold, with high static-hold pads and a high-gloss black powder coat finish that matches common Wilwood kits. Search terms: MC4 parking brake caliper right hand, cable-operated rear parking brake caliper, 1.19 piston 0.81 rotor, Wilwood parking brake retrofit.
The manufacturer's install documentation states that OEM brake lines will not adapt to Wilwood calipers. The manufacturer's preferred method is steel adapter fittings at the caliper with enough braided line to allow for full suspension travel.
Per the manufacturer, the mechanical lever accepts a .310" diameter barrel-ended parking brake cable. The manufacturer's universal parking brake cable kit, P/N 330-9371, is sold separately and is listed for use with the MC4 caliper.
The manufacturer offers this caliper as part of kits rather than as a bolt-on for a stock vehicle, and it appears in the manufacturer's rear retrofit, C-clip eliminator, and Miata kit instructions. Confirm your application with the manufacturer before ordering.
Per the manufacturer, installation should only be performed by persons experienced with disc brake systems. In retrofit applications, the manufacturer says to discard the old caliper mounting bracket and maintain a minimum of .080" clearance between the wheel and caliper in all areas. Route the parking brake cable as straight as possible, because the manufacturer notes that bends reduce pull force at the brake and recommends a minimum bend radius of 6". Once the caliper is mounted, the manufacturer's instructions call for adjusting the caliper per the kit instructions, and in the retrofit steps, backing off the adjustment bolt one-half turn on each caliper before testing holding power.