This is the left-hand version of Wilwood's MC4 Mechanical parking brake caliper, a single-piston, cable-operated unit for vehicles that need a standalone, mechanically actuated parking brake. The body is die-cast aluminum with a forged billet anvil, and the 1.19-inch aluminum piston is fully dust-booted. The manufacturer lists it for 0.81-inch rotors in the 11 to 14-inch diameter range, and it weighs about 3.30 pounds (2.95 without pads). Choose it over a stock or improvised parking brake when you want the parking function to work independently of the hydraulic calipers, which matters on setups with fixed four-piston main calipers. Its high-gloss, high-temp, brake-fluid-resistant powder coat is also a step up from bare hardware.
Parking brake duty is where an MC4 earns its price, because the caliper is designed around a separate, hand-operated application rather than hydraulic pressure. The manufacturer notes noise-dampening features for quiet, rattle-free operation, which owners on user forums often weigh against cheaper cable calipers. For a rear-axle installation on a classic or track build, search terms like "left hand cable parking brake caliper 0.81 rotor," "MC4 parking brake 120-12070," and "1.19 piston mechanical parking brake caliper" will match this part. Fitment hinges on rotor thickness, so confirm the 0.81-inch width against your disc before ordering. The lever can be clocked to three positions to suit cable routing, and the caliper accepts a .310-inch barrel-ended parking brake cable.
The manufacturer's listing identifies the silver 120-12070 as the left-hand caliper. The right-hand counterpart is the 120-12069 in the same finish.
The manufacturer specifies a 0.81-inch rotor width for this part number. The company builds MC4 calipers for specific rotor thicknesses by part number, so match this caliper to a 0.81-inch disc rather than a different width.
The manufacturer states the lever accepts a .310-inch diameter barrel-ended parking brake cable, and each caliper includes a cable return spring.
This is a cable-actuated caliper, so there are no hydraulic lines to run and no brake fluid bleeding to perform. The main job is mounting the caliper and bracket on a 0.81-inch rotor, then routing the parking brake cable through the lever. Because the lever clocks to three positions, set it before tightening the cable path so the cable does not bend sharply or rub. Confirm the bracket mounting pattern and any torque values against the manufacturer's install sheet before starting, since those details were not confirmed in my research.