The Wilwood GP310 rear caliper, part 120-7740-BK, is a billet aluminum, four-piston motorcycle caliper with a black powder-coat finish. The manufacturer lists it for Harley-Davidson motorcycles from 1984 onward, not for cars. It is a right-hand unit with stainless 1.25-inch pistons, sized for a rotor 0.25 inch wide and 11.50 inches in diameter on a 3.50-inch lug mount. Owners on user forums who replaced factory hardware describe a large jump in stopping power, though opinions differ on how it compares with higher-end sport-bike calipers. Because the price is well above salvaged sport-bike calipers, buyers should expect a real performance gain to justify it. Searches for a Harley rear caliper upgrade, GP310 bracket fitment, and 3.50 lug mount Dyna or Softail brake setups will lead to this part.
The caliper ships without its mounting bracket, so a separate GP310 bracket kit is required. The manufacturer offers bracket kits by model family, including 1984–1999 Dyna and Softail versions and 2000-and-up versions. Owners on user forums say the caliper bolts on directly once the correct fasteners are sourced, and one owner reported needing two 3/8-16 x 1 inch bolts per caliper that were not supplied. Bleeding is the main DIY challenge. The bleed screws sit on the inboard side, and owners on user forums say a fender can block wrench access, so plan for a bleed-screw tool and a clean work area before you begin.
No. The manufacturer designs this GP310 rear caliper for Harley-Davidson motorcycles from 1984 onward. Confirm your exact model year with the manufacturer before ordering.
No. The manufacturer's product literature lists the caliper without its bracket. Bracket kits are sold separately for specific Harley families, and a caliper mounting bolt kit is also available.
Owners on user forums report that the caliper works with stock rotors. However, the manufacturer's literature gives its dimensions for an 11.5 inch by 0.20 inch disc, while the product specs list a 0.25 inch rotor width. Confirm rotor thickness with the manufacturer before fitting.
Installation is a moderate-difficulty job for a home mechanic who has done brake work before. Order the correct bracket kit for your model year and the mounting bolts before you start, since owners on user forums report the bolts are not included. Per the manufacturer's general bleeding guidance, most Wilwood calipers have two bleed nipples and some have four. Do not bleed the downward-facing lower screws, and start with the wheel farthest from the master cylinder. Fluid choice needs care: the manufacturer's literature says Harley-Davidson specifies DOT 5 silicone fluid, while the manufacturer's bleeding bulletin says DOT 5 silicone is not recommended for racing or performance driving. Details vary, so confirm the correct fluid with the manufacturer before bleeding.