The Wilwood GP310 front left-hand caliper in black powder coat is a billet aluminum, four-piston motorcycle caliper made for 1984–1999 Harley-Davidson models. The manufacturer says it uses stainless steel pistons to limit brake fade and resist corrosion, with high-temperature piston seals and bright-finish bleed screws. Owners on user forums describe a large improvement over the stock front caliper, which makes this a practical upgrade for riders who want more stopping power and smoother lever feel. The black finish also matches the stock look more closely than the polished or chrome options.
The manufacturer describes the GP310 front as a direct leg-mounted design for single and dual disc models, and it notes that this left-hand unit locates on the bottom side of the rotor. Owners report that it bolts on without lifting the bike or pulling the front wheel. You will need two 3/8"-16 x 1" bolts per caliper, which are not included. Expect the bleed screws to sit inboard behind the caliper, where a fender can block a wrench, so a short-handle or ratchet wrench and a patient bleeding routine are worth planning for.
The manufacturer lists the GP310 front caliper for 1984–1999 Harley-Davidson motorcycles and describes it as direct leg-mounted for single and dual disc models. Confirm your model year, disc setup, and rotor size with the manufacturer before ordering.
No. Owners on user forums say the caliper needs two 3/8"-16 x 1" bolts per caliper, and these are not supplied with it.
Owners on user forums say the GP310 works as a direct bolt-on replacement and that the stock rotors can be reused. Check rotor specifications with the manufacturer if you plan to change rotors.
Owners on user forums describe this as a straightforward bolt-on job that does not require lifting the bike or removing the front wheel, but it is not a no-tools swap. Plan on two 3/8"-16 x 1" bolts per caliper, a ratchet or wrench that fits the inboard bleed screws, and a fluid bleeding setup. The most common complaint is bleeding: the bleed screws sit behind the caliper and can be difficult to reach with the fender installed. One owner suggests tying the brake lever back overnight so trapped air can rise, then re-bleeding after the system settles. Verify pad compatibility with the manufacturer before installation.