The Wilwood GP320 caliper (MPN 120-15753) is a compact, four-piston race caliper built from billet alloy for 0.81-inch-thick rotors. The manufacturer says its CNC-machined body uses stainless steel pistons, which resist corrosion and slow heat flow from the pad into the caliper body, seals, and fluid. Each of the four pistons measures 1.25 inches, so the caliper gives a full, even clamp on a thin race rotor without adding bulk.
Over a two-piston design, the four-piston layout spreads pad load more evenly, and the manufacturer credits that with sharper pedal response and longer pad life. The GP320 pad footprint is also larger than many two-piston calipers used on similar cars. Quick-Clip retention pins let you change pads without removing the caliper, which saves real time between sessions. The manufacturer lists the GP320 family at about 1.70 pounds, a useful weight difference on lightweight open-wheel chassis.
This is a lug-mount caliper with a 3.50-inch mount center, made for rotors between 9.00 and 11.50 inches in diameter. It suits sprint, midget, mini-sprint, flat-track motorcycle, and small formula racers. Because the dual bleeder layout allows left or right installation, owners on user forums warn that a caliper on the wrong side puts the bleeder at the top and traps air. Search terms this part matches include GP320 4 piston caliper 0.81 rotor, 3.50 lug mount race caliper, and 1.25 inch stainless piston sprint car caliper.
Yes. The manufacturer lists this part number with a 0.81-inch disc width, and its GP320 documentation gives rotor diameters from 9.00 to 11.50 inches.
The manufacturer describes a dual bleeder design that allows left or right installation. Owners on user forums report that a caliper mounted on the wrong side puts the bleeder at the top, so confirm the bleeder sits at the low point before you bleed the system.
The manufacturer specifies a 1/8-27 NPT inlet. Its install guidance notes that rubber brake hoses generally cannot be adapted to Wilwood calipers.
Wilwood's install sheet for GP320 spindle-mount kits says to fit the caliper first, using clean, dry threads on the mounting bolts, and to place shims between the bracket and caliper so the caliper centers on the rotor. Remove the pad pin retainers before you set the pads. Secure the bolt with thread locker as the sheet specifies, and make sure the bottom bleed screws are tight. Most GP320 kits are installed with common hand tools, but centering and clearance checks take patience. Do not connect a rubber hose, because the manufacturer says those generally cannot be adapted. Confirm the bleeder orientation before you bleed the system, since a reversed caliper will trap air.