The Dinan D210-2024 is a 6mm wheel spacer set sold as a pair for 5x112 hubs with a 66.5mm center bore. Each spacer is CNC-machined from billet 6061 aluminum, has a weight-saving design, and carries an anodized black finish. Dinan's spacers move the wheel outward from the hub, which creates the offset needed for a more aggressive stance or extra room for brake calipers.
Dinan positions its spacers on precision rather than generic fit. The manufacturer describes them as engineered for exacting bolt-pattern accuracy and hub-centric design, and its earlier BMW-specific spacer kits were designed to avoid the balance problems owners associate with universal spacers. A 6mm step suits BMW owners who want a flush look or added caliper clearance without the larger offset change of thicker spacers, and the machined build is a better match for performance use than a cheap universal spacer. Owners on user forums have shared mixed experiences, so buy the bolts Dinan specifies and do not skip the install steps below.
Fitment follows the manufacturer's application guide: G-chassis vehicles use a 5x112 pattern with M14x1.25 lug studs, and Dinan lists the F9x M5/M8 and F48/F39 X1/X2 as examples that use this G-chassis spacer fitment, though exceptions apply. Spacers add length to the lug-bolt engagement, so longer bolts are required and are sold separately. Owners on user forums on the G05 X5 report stock bolts around 27mm and say the bolt length must grow by the spacer thickness. Confirm the exact length for your wheel setup before installing. Search terms: 5x112 66.5mm spacers, M14x1.25 G-chassis wheel spacers, 6mm hub-centric billet spacers, BMW F9x and G05 spacers.
Yes. The manufacturer states that longer bolts are required when using wheel spacers. They are sold separately, and the manufacturer lists suggested bolt lengths for each spacer kit. Match the thread size to the application guide.
The manufacturer's general application guide lists G-chassis vehicles as using 5x112 spacers with M14x1.25 bolts. It names the F9x M5/M8 and F48/F39 X1/X2 as examples of that G-chassis fitment and notes that exceptions apply. Check your chassis code before ordering.
Owners on user forums say the bolt length needs to increase by the spacer thickness. One G05 X5 owner reported stock bolts of about 27mm. Confirm the exact length with the manufacturer before ordering, especially for non-stock wheels, which owners say require their own measurements.
This is a moderate DIY job. You will need a floor jack, jack stands, a lug wrench or impact tool, and a torque wrench. Dinan's install sheets for its other spacer kits say not to work on a vehicle supported only by a jack, so use jack stands. Mark which bolts belong to the front and which to the rear, because mixing them up is a known risk. Owners on user forums report one bolt failure on a different Dinan spacer set, which the manufacturer attributed to over-torquing, so tighten to the torque value in the bolt and vehicle instructions and no higher. Once installed, check tire and rim clearance against the strut tube and other nearby components. Dinan's sheets for other kits call for at least 1/8" of clearance at the strut tube.