The H&R 14254301SW is a single black wheel bolt with an M14x1.25 thread, a 43mm shank, and a 60-degree tapered seat that turns with a 17mm wrench. The manufacturer's listing for the black 14 X 1.25 bolt matches these dimensions, and H&R also sells it as a 10-piece set. The bolt suits anyone who runs a wheel spacer and needs hardware longer than the factory bolts. The manufacturer's guidance says new bolts must be longer than the original bolts by the width of the wheel spacer used, so a correctly sized H&R bolt keeps the wheel properly clamped instead of relying on a guessed length. Owners on user forums often point to the same reason for buying a matched set rather than mixing hardware.
Thread engagement is the main safety point. For M14x1.25 hardware, the manufacturer's application notes call for 9.0 turns = approx. 12mm of load bearing shaft length. Start each bolt by hand so it spins freely and does not cross-thread, then tighten in a star pattern with a torque wrench set to your vehicle or wheel manufacturer's specification. Before final torque, rotate the wheel by hand to confirm it clears the hub and that no bolt contacts ABS sensors or brake components. Because the seat must match the wheel, confirm the 60-degree cone fits your wheel's bolt holes before ordering, especially for long-tail searches such as "M14x1.25 60 degree cone seat wheel bolt 43mm."
The manufacturer says to add the spacer thickness to the length of the current wheel screw to determine the new shaft length. Measure your existing bolt first, since the 43mm length here is only correct for a specific spacer thickness.
The manufacturer's application notes specify roughly 9.0 turns, or about 12mm of load-bearing shaft, for M14x1.25 bolts. Anything less is unsafe, and the bolt should not bottom out or contact brake or ABS parts.
This is a moderate DIY job that needs a 17mm socket or spanner, a torque wrench, and a way to lift and support the vehicle safely. Remove the wheel, fit the spacer flush against the hub if you are using one, and insert the new bolts by hand until they spin freely. Tighten in a star pattern to the specification from your vehicle or wheel manufacturer, then recheck the wheel for free rotation and clearance. Avoid impact guns, which can overtighten the bolt. Those with brake or ABS clearance concerns should consult the manufacturer before finishing the install.