H&R's 1456006SW set gives you ten black 14 x 1.5 bolts with a 60 mm thread length and a 19 mm hex head, built around the Porsche Ball, R14 seat that the manufacturer lists for this part. The manufacturer's lineup of this thread runs from 52mm to 74mm, so you can match the bolt length to your spacer instead of guessing. Extended bolts are needed when a wheel spacer is fitted between the wheel and the axial hub using longer bolts. Documented seat type, length, and head size let you verify a 14x1.5 Porsche ball-seat extended bolt before torque is applied, which matters for a track or spirited-driving setup.
For fitment, owners on user forums note that Porsche has used 19mm-head wheel lug nuts and (later lug bolts) since at least the 1970s, though some newer cars have moved to 17 mm bolts, so verify your model year first. The manufacturer's spacer instructions say the thread length of the H&R wheel bolts must always match the thickness of the wheel spacer, and that minimum thread reach should be checked. Owners quoting Porsche documentation list Black wheel bolts = 118 ftlb. for 997-era cars, so confirm the figure for your specific vehicle before torquing.
The manufacturer states that its bolt thread length must match the thickness of the spacer, and that minimum thread reach should be verified before installation. Measure your spacer thickness and confirm the required length with the manufacturer before ordering.
Owners on user forums report 118 ft-lb for black Porsche bolts on 997-generation cars, while older silver bolts were specified at 96 ft-lb. Values vary by model and wheel, so confirm the figure for your car with the manufacturer or your service manual.
Owners on user forums say Porsche has used 19 mm heads for decades, but some recent models have moved to 17 mm bolts. Check your vehicle's head size before ordering.
Installation is manageable for a home mechanic, but the critical points are correct length and torque rather than tool access. You will need a 19 mm socket, a calibrated torque wrench, a jack and stands, and a wire brush to clean the hub face. Thread each bolt in by hand to avoid cross-threading, then tighten in a star pattern rather than around the circle.
Owners quoting Porsche's 997.2 service manual advise cleaning the bolts first and applying a thin aluminum paste to the threads and between the head and spherical cap, while keeping the cap's bearing surface free of grease. The manufacturer's spacer instructions call for re-tightening the bolts with a torque wrench after initial driving, so schedule a torque check after your first drive.