The H&R 1453703SW is a 14x1.5 wheel bolt with a 37mm thread length, a 17mm hex head, and a VW/Audi ball seat, finished in black. This listing is the ten-piece set, which covers a full set for a wheel and spares. H&R's ball-seat design is the factory-style interface for many VW and Audi wheels, so these bolts suit owners who want a black lug bolt that matches a ball-seat wheel without changing the seat. The longer 37mm shank gives more thread length than shorter stock-length bolts, which matters when you run a wheel spacer or a thicker hub face. Cheaper generic bolts rarely document their seat radius or length, and a mismatch can hurt wheel clamping, so a documented H&R part is the safer buy. Search terms owners use include 14x1.5 ball seat wheel bolts VW Audi, 37mm black lug bolts, H&R 1453703SW set of 10, and ball seat wheel bolts for spacers.
Before ordering, confirm your wheel's seat type. Pull one wheel and check the lug hole: a rounded, bowl-shaped recess means ball seat, while an angled cone means conical. Owners on user forums warn that a ball-seat bolt in a conical aftermarket wheel touches only a thin edge, which can deform the wheel and lose clamp load, so these bolts are not a fit for conical-seat aftermarket rims. Installation is straightforward with a 17mm hex socket and a torque wrench, but use the vehicle manufacturer's torque value for your wheel and hub, and keep threads clean and dry unless the vehicle or wheel maker says otherwise. If you are adding spacers, check that the 37mm length still gives full thread engagement in your hub before you torque the wheel down.
No. The manufacturer specifies a VW/Audi ball seat for this part. Owners on user forums report that ball-seat bolts in a conical-seat wheel make contact only on a thin edge, which can damage the wheel and reduce clamping force. Check your wheel's seat type first.
The manufacturer lists the 1453703SW as a single bolt, and separately lists the SET version with a quantity of 10. This product is the set, so confirm the quantity your wheel setup needs before ordering.
The manufacturer does not publish a torque value on the listing used for this research, and the vehicle maker's torque specification applies. Owners on user forums report using the same torque on VW ball-seat wheels for aftermarket and OEM wheels, but confirm the value with the vehicle manufacturer before torquing.
This is a beginner-to-intermediate job that needs a 17mm hex socket, a breaker bar, and a calibrated torque wrench. Support the vehicle securely, remove the wheel, and check the hub threads and the wheel's ball-seat recess for debris before fitting. Start each bolt by hand to avoid cross-threading, then tighten in a star pattern to the vehicle manufacturer's specified torque. Re-check torque after a short drive, since a loosened bolt is the main risk. The most common mistake is mixing seat types: a ball-seat bolt in a conical wheel will not clamp correctly, even at the right torque.