The BAK BAKFlip MX4 EZ-Lift is a hard folding tonneau cover for the 2023–2026 Chevrolet Colorado and GMC Canyon with the 5'2" bed. It is built on the MX4 hard-fold platform with an EZ-Lift update aimed at one-handed opening. Compared with a soft cover or a bargain clamp-on, its main advantage is bed access: per the manufacturer, folding the panels forward against the cab exposes the whole bed while the cover stays mounted, so oversized loads never require removing it. The manufacturer says third brake light visibility stays unobstructed in any position on this MX4 line.
Installation is a bolt-on job. The manufacturer describes a bolt-on process using the included tight-fit clamps, with no cutting, trimming, or drilling. The manufacturer rates it Level 1 simple and quotes 30 minutes or less. Searches for a 5 ft bed hard tonneau, Colorado EZ-Lift one-hand operation, and no-drill Canyon bed cover tend to lead to this part, so fitment should be checked against the manufacturer's chart for your exact trim before ordering. Fitment: 2023–2026 Chevrolet Colorado and GMC Canyon, 5'2" bed.
The manufacturer states that the MX4 line leaves the third brake light visible in any position, including when the cover is folded.
No. The manufacturer says the cover uses the included clamps for a bolt-on installation, with no cutting, trimming, or drilling required.
No. According to the manufacturer, you fold the cover to the cab, secure it, and drive; removal is not needed for large loads.
The manufacturer rates this a Level 1 install that takes about 30 minutes, with all necessary hardware included. The manufacturer's general BAKFlip install sheet advises snugging each clamp, then adding roughly a half turn, and applying downward pressure on the rail while tightening so it sits flush and seals properly. That sheet covers an earlier Colorado and Canyon generation, so confirm the model-specific instructions for the 2023–2026 truck before you start.
