The H&R 72756-2 is a matched front and rear sway bar kit (28mm front, 24mm rear) for the Volkswagen MK6 Golf and GTI with the 2.0T, 2.5L, and TDI engines. H&R Sport Sway Bars are crafted from a special (hf) 50CrV4 steel alloy, and production is completed in-house at H&R's ISO9001 certified facility in Germany. The bushings use a urethane/Teflon composite that prevents squeaks and eliminates the need for lubrication. Larger-diameter bars raise roll stiffness, so the car leans less in corners and tracks more predictably than it does on stock bars.
Owners on user forums describe the 28/24 setup as a real step up in cornering stiffness, though one who ran it on a daily car found it a bit too much for a road car especially on a wet bumpy road. If you mainly drive back roads and autocross, this kit suits a MK6 GTI or Golf 2.0T/TDI owner who wants less understeer without lowering the car. Confirm the application for your exact model year with H&R before ordering, because fitment details vary across sources. Searchers looking for a MK6 GTI 28mm front sway bar, a 2.0T sway bar kit, or a MK6 Golf 2.5 TDI anti-roll bar upgrade will find this kit's core specs below.
Owners on user forums report that the front bar is the harder job, and that the subframe must be lowered about an inch to swap it, though it does not need to come out completely. The rear bar is the easier of the two.
Owners on user forums advise replacing the subframe bolts once they have been loosened, rather than reusing them.
The manufacturer states that the urethane/Teflon composite bushings are designed to prevent squeaking and eliminate the need for lubrication.
Experiences vary. Some owners on user forums find the 28/24 combination firm on rough or wet roads, while others who run the same kit say it is not prone to snap oversteer. Choose based on how much ride firmness you will accept.
The front bar is a moderate-to-hard DIY job, and the rear is considerably simpler. Owners on user forums who have fitted a MK6 GTI front bar recommend jacking the car onto sturdy stands and removing the front wheels, since working with the wheels on the ground made the old bar harder to remove and the new one harder to seat. No special tools are needed for this upgrade, but a second person helps when lowering the subframe. Label the hardware as you remove it, because you are going to have a bucket of loose bolts by the time the old bar is out. Forum installers also note that the sway bar end links should be connected with the suspension loaded, so plan to lower the car onto its wheels for the final tightening.