The H&R 71490 is a 20mm fixed-rate rear anti-roll bar for the E92 3 Series coupe, covering the 328i, 335i and 335is from 2007 through 2013. The H&R rear bar increased from the factory 13mm to 20mm, which owners describe as a very noticeable jump in stiffness. Stiffness increases to the 4th power relative to incremental bar diameter increases, so this 7mm step changes rear roll resistance far more than the numbers suggest.
Compared with stock, the stiffer rear bar targets understeer and body roll mid-corner without changing ride height. Owners on user forums who fitted a larger rear bar to a 335 report that understeer is minimized. A rear-only upgrade has tradeoffs, though. Enthusiasts on user forums warn that a rear sway bar without a limited-slip differential can cause the inside rear wheel to lose traction under power. Owners often suggest looking into stiffer springs and better dampers before or alongside a rear bar.
Owners on user forums generally advise caution with a rear-only change, since a stiffer rear bar can push the car toward oversteer. Several owners suggest balancing front and rear bar stiffness, and some note the rear bar is better paired with a limited-slip differential.
Owners on user forums report that the rear subframe must be lowered to access the factory bar. Several owners describe loosening the subframe bolts, disconnecting the brake lines, and dropping the subframe only a few inches for clearance.
One owner on a user forum reported that the rear bar took about 2–3 hours to install on an E90 330i. Owners on user forums also describe the job as manageable for a home mechanic with jack stands and a helper.
The rear bar is a moderate-difficulty job because access requires dropping the rear subframe rather than simply unbolting the bar. Owners on user forums recommend supporting the car on jack stands, placing a floor jack under the subframe, and removing its four mounting bolts, while disconnecting the brake lines and lowering the exhaust hangers for clearance. Having a second person to guide the curved bar in and out makes the job noticeably easier. Owners frequently replace the subframe bushings during the same job, citing the stock units as a weak point. Budget a few hours and an afternoon for the first attempt, and check the manufacturer's install diagram for correct bar orientation before tightening everything down.