The KW Electronic Damping Cancellation Kit (part 68510390) is a plug-in module for BMW F80 M3 and F82 M4 cars built with factory Electronic Damper Control (EDC). Owners on user forums describe it as a way to keep the car's systems from flagging the swap when you fit coilovers or lowering springs, with the stock damper control itself left switched off (kw unit basically makes the car think the adaptive suspension is still there without actually switching it off.). If you are searching for an F82 M4 EDC delete, BMW F80 M3 electronic damper control cancellation, or a fix for dash warnings after coilovers, this is the hardware-based option for that job.
The main alternative most owners weigh is software coding of the EDC option. Forum members who went that route describe changes across several modules, including stability control, the instrument cluster, and the head unit (remove 2VF from FA, and VO Code but you have to hit a few more modules: DSC, KOMBI (to update the instrument panel), ICM, and HU_NBT.). The plug-in module avoids that coding session, which is the real case for paying for it. Be aware that the adaptive steering behavior goes away with the factory dampers, and owners on user forums note that the car may handle funny if previously on the adaptive suspension (variable steering will be gone.
Fitment details vary across listings, so check your chassis and model year against the manufacturer's application list before ordering. Installation is mostly about the wiring. One forum owner found the pin layout did not match the instructions and had to crack open the stock connector to use other connectors to lock into the adapter (which would in turn connect to the EDC sensor). Owners searching for a BMW M3 M4 EDC fault code fix after lowering springs should plan for that extra time.
Yes, this is a hardware alternative. yeah, you just vo code the option back in. to remove: remove 2VF from FA, and VO Code but you have to hit a few more modules. Owners on user forums describe the module as the route that avoids that multi-module change.
User forums report mixed results. One owner found the extra sensor no longer seems needed once the KW EDC Delete unit is in place, or I haven't figured out yet if anything isn't working properly because of it. Confirm the sensor question with the manufacturer before you remove or relocate it.
Plan for a wiring-heavy job rather than a bolt-on swap. A forum owner said the wiring took more time than replacing the shocks and springs. At the rear, you're supplied a new gasket and shorter bolts because you do not mount the "distance" (housing that contains the OEM edc connection to the shock). Budget time to fit the modules securely in the body, and expect to cross-check the wiring against the manufacturer's instructions, since at least one owner found the pinout did not match.